Your cart is empty.
Your cart is empty.Product Description
CUSTOM WIRING DONE RIGHT
Facilitate circuit-to-circuit wire connections with double row barrier strips. Screw terminals easily accept mini fork / spade / ring connectors.
- Pin Pitch: 9.525mm
- Wire Range: 22 – 12 AWG
- Temperature Rating: -40°C to 105°C (-40°F to 221°F)
- Insulation Resistance: 500 MΩ
- Rated Voltage/Amps: 300V/20A | Withstand Voltage: AC2000/Min
- Housing: PA66, UL-94V-0
- Terminals: Tin-plated brass terminals, nickel-plated steel screws with bolt-size #6 (M3.5 metric)
- Torque: 0.5 N*m, 4.4 LB*in
BARRIER JUNCTION STRIP
Screw terminals can accommodate connector with ring / fork diameter up to 8mm wide. Each pair of connected screws are physically separated by insulated barriers from neighboring screws.
WELL-DESIGNED
After mounting the terminal strip in your location of choice, wiring is a straightforward task. The wire connections are completed on the surface screws, which can accommodate wire up to 12ga.
DIFFERENT SIZES
MGI offers multiple sizes to fit your needs, ranging from 2 to 12 circuits. Designed to withstand temperatures up to 221F (105°C), with high-quality tin-plated brass terminals and nickel-plated steel screws.
Jason Purvis
2025-09-05 17:48:07
Fit perfectly
Robert Woods
2025-08-27 14:55:58
I am long time user of small to large terminal strips---the two that I received are excellent in design and construction---the only thing better that that was they were at my front door next day! Will order again as I check my inventory. Thanks
John Prine is my co-pilot
2025-08-20 12:27:00
Simple to use but absolutely necessary when wiring your model train layout.
trkdrvrman
2025-08-01 17:02:41
there isn't much to these they work wish the spaces in between had more room but it is what it is they did what I needed them too
R. Sharples
2025-07-29 18:44:41
As you can see in my photo, the picture in the Amazon listing shows that the plastic barriers between the sets of terminals are significantly higher than tops of the screws while the part that I received has barriers that are lower than the tops of the screws. If one were to secure a stranded wire under the screw, the barriers should ideally block the wire strands from being able to touch an adjacent terminal. With the barrier as low as these are, that may not happen. While I plan to use ring terminals on the wires with this terminal strip I would not have purchased this product if the picture had been accurate.
Pancho
2025-06-30 11:16:34
Smaller then picture.
james salveson
2025-06-01 15:08:58
smaller than exspected
Richmond Hughes
2025-05-20 11:25:26
Good Deal
Jean-Yves Ouellette
2025-04-28 16:25:46
Good bus bar to wire any project and limit wiring
John
2025-04-27 10:54:23
works, no complaints.
Fox on the Run
2025-04-23 13:39:55
Works Perfect.
Bob Kreutzer
2025-03-29 13:25:11
Wiring
Lorne
2025-01-25 13:41:19
Product was as advertised. Perfect for the job.
Recommended Products