Your cart is empty.
Your cart is empty.
The Monstrum Q Series scope rings are the latest addition to our best selling line of scope ring and mount products, offering the same level of dependability and craftsmanship with an added twist - a quick detach lever that secures and detaches in an instant with the flick of the wrist.
The simple to operate quick release lever mechanism can be tightened quickly and securely by hand with no additional tools required. Swap out your optic in seconds. Leave your tool kit at home. Simply twist to tighten and twist the other way to detach. The lever position can be re-oriented by pulling and releasing.
Available in both 1 inch and 30 mm diameter sizes. They are compatible with both Picatinny and Weaver mounting platforms.
Rings are secured with Torx mounting hardware to protect from stripping.
The Q Series scope rings are available in Low (0.80 inch height), Medium (1.00 inch height), and High (1.20 inch height) Profile as measured from the center of the rifle scope tube to the bottom plane of the ring base.
All Monstrum products are backed by a lifetime guarantee.
Clayus Denarii
2025-08-30 10:35:19
The QD rings work well. Already installed!
Customer
2025-08-10 15:26:11
They work very good
Justin Q.
2025-07-29 14:44:02
I needed a set of scope mounts for a project. I didn’t want to spend a lot of money on a set that would be used for mock-up. These fit the bill. They are sturdy and will do what I need them to do. Would I use them on a more quality build? Probably not. But they do fit the need for something to give me a good start for proper scope height, clearances, etc when looking for the ideal mount in a higher price range. The mounts are secure and stable when tightened down. The good part is it doesn’t matter if they get worn from use, that’s why I chose them for the price.
R. B. Farley
2025-07-18 14:50:17
Bought two sets of these after watching a video review from some hillbilly saying they were good. Since I'm a hillbilly too, I figured, what could go wrong? Used one set to re-mount a scope on my .308 as the rings on it had the scope practically laying on the barrel. Made operating the bolt a knuckle-smashing event. Didn't like that. These give it enough height that the bolt can be operated painlessly. That, I like. The .308 uses weaver rails, and while these do fit, they took a little persuading to get on correctly. Second set was to mount a scope on my S&W AR and this went much smoother with the picatinny rail on the AR. Doesn't raise it over the front sight, but the scope optics take care of that. Time will tell how well these hold up, but I'm happy with them.
Timmy & Bonnie
2025-07-06 16:29:07
Fit perfectly, better price than Leopold so noone having Leopold in stock that led me try Monstrum and glad I did and saved money.Bought 2 pairs, 30mm
Customer
2025-04-21 17:08:16
Haven't fired over them yet but they seem pretty sturdy for how inexpensive they were. I like the fact that the levers can be pulled out and oriented symmetrically once tightened onto the picatinny. Would be nice if they had 4 screws per ring but will see how they hold up.
Curtis Siple
2025-03-20 12:47:10
These are my favorite rings, easy to instal and quick release in just a few seconds allowing me to change scopes quickly for doing long range work to quick close moving targets and both scopes stay zeroed because of their quality craftsmanship ! Excellent price for the high quality !
Alan
2025-02-17 10:47:05
These are nice rings for the price but the diameter of the bolt is too big to fit in the slot of Weaver mounts.
Recommended Products
