Your cart is empty.
Your cart is empty.Product Description
Murray GFCI plug in circuit breakers are intended for use in Murray load centers or meter combinations. The single pole Murray breakers may be used in 1 or 3-phase load centers and are 120V rated. To ensure the warranty on a Murray panel is not voided, the use of Murray breakers is required. The GFCI is intended for areas required by code to have ground fault protection, such as bathrooms, kitchens, and outdoor circuits. Check with your local electrical inspector to confirm. The use of a double pole AFCI allows for shared neutral applications in which two circuits will share a common neutral.
From the Manufacturer
Murray GFCI plug in circuit breakers are intended for use in Murray load centers or meter combinations. The single pole Murray breakers may be used in 1 or 3-phase load centers and are 120V rated. To ensure the warranty on a Murray panel is not voided, the use of Murray breakers is required. The GFCI is intended for areas required by code to have ground fault protection, such as bathrooms, kitchens, and outdoor circuits. Check with your local electrical inspector to confirm. The use of a double pole AFCI allows for shared neutral applications in which two circuits will share a common neutral.
Thomas Ellis
2025-08-14 12:28:40
I felt this was a good price for this breaker. Seems to work just fine (i.e.., testing always tripped the breaker). Installation tip for DIYers: after connecting the black power lead, follow that wire back to the cable where it enters your service panel, locate the corresponding white neutral wire, then disconnect that wire from your grounding bus and connect it to the load neutral screw of your new breaker. The instructions come with a picture. You will also need to connect the white pigtail that comes with the breaker to your neutral bus. Depending on the length of your relocated white wire, you may need to rearrange a breaker or two to get them all back on the panel.
Dave
2025-07-20 18:07:35
Works fine. Price was reasonable.
David A Welsh
2025-07-17 17:44:58
Easy install, have power to the shed now
Andrew
2025-07-13 13:53:31
Ordered 3 and got....3, BUT 2 were branded Gould a company that Murray Bought out years and years ago (cant remember what year but a long time ago), before Siemens bought out Murray years ago. You got the point looked, must have been new old stock the other 1 of the 3 was literally unbranded. I never tried to get working or anything just sent them back. I always keep a panel under 1 brand at most I'll mix Murray and Siemens. Also these 3 breakers looked like the 1990s all over again.
Fess
2025-05-23 20:17:26
A little pricey because it is a 15 amp rather than the 20 amp industry standard. Installed, tested and working
tony catona
2025-04-08 09:46:57
Good item, did what it should.
N. Horvath
2025-02-18 12:46:58
Worked as expected. Fits in my old Murray arrow heart panel. Provides gfci protection for the whole circuit so gfci outlets are not necessary.
MarkC
2024-12-10 16:24:55
Fit perfectly as a replacement in a Crouse-Hinds sub panel.
Recommended Products
$75.99
$ 35 .99 $35.99