Your cart is empty.
Your cart is empty.Product Description
Flako987
2025-08-09 11:10:58
Great socket, worked perfectly for my application which was a 2010 corolla, but pretty sure it fits a wide range of other car models since this is a very common size for O2 sensors
VG
2025-07-26 10:12:02
Solid, easy to use, just what you need for downstream oxygen sensor replacement
Cliff
2025-07-19 16:14:06
Used on a 2006 Honda CR-V, this socket allows removal without having to take the heat shield off
Richard
2025-07-03 17:19:16
Car engine light was on (2005 Honda Accord EXL). Connected my OBD adapter and it showed an O2 sensor error.Used this socket to remove and install the new sensor. All was fine. Great price for this socket. Lot less than store price.Notes:- Socket is not a perfect fit for O2 sensor. When the socket is attached to the O2 sensor, there is slight wiggle (clockwise / counter clockwise). Maybe the O2 sensor is a little smaller (width wise). - out of spec. maybe.- Some catalytic converters have that have that lip at the entrance where the O2 sensor is. If that lip is too deep, the socket will not fully attach to the O2 sensor. (may need to cut away the metal lip - like I have seen on videos.Overall, good price. Does the job.
Larry W. Boomer
2025-06-27 12:43:16
Heavy duty tool to get into tight places.
dgracer
2025-05-31 18:46:59
Heavy duty o2 sensor remover. A must have tool when when removing. Good for tight areas vs longer socket type
Jeffrey Watkins
2025-02-18 14:16:58
Great quality and price. Would highly recommend ðŸ‘
Nina
2024-12-18 11:02:08
I bought this adapter so I wouldn’t struggle with the regular wrench. Although I tried the 22 wrench first, it was so hard it wouldn’t even budge. Then I used the adapter and boom it came off within 5min. The best tool to use if you’re trying to replace your oxygen sensor!
Recommended Products
$18.95
$ 9 .99 $9.99