Your cart is empty.
Your cart is empty.This fill adaptor is for 1/8 NPT thread,most commonly seen on remotes and fill stations.Will fit any bottle. Heavy duty aluminum. It includes backup orings to you, it means that you can replace the oring and use it longer.
J
2025-08-03 16:05:22
I bought this to check the output pressure on my paintball regulator. I bought a 1/8" plug to seal the other hole. It works just fine. I will probably switch the plug out with something that will allow me to bleed the pressure after shutting it off.
Chris
2025-07-14 13:55:01
I used this for a different purpose to check the output pressure of my tanks by putting another gauge on the open side. Worked great, found out my 800 psi regulator was actually 600 psi. Just be mindful that using it on higher pressure tanks can make it hard to remove, but they did include a relief hole on the side so it should degas before you fully unscrew it.
a reader
2025-06-04 11:43:34
It works fine and seems durable enough. The pin valve operates smoothly, the thread vent works properly when unscrewing the cylinder under pressure, and the unit is nicely machined and finished. Annoyingly, however, the little gauge has very poor markings (basically can't read an actual pressure with it), isn't screwed in so the dial is upright (it's at a random angle compared to the body), and is loctite-ed in place extremely securely with the red stuff. So you can forget about straightening it up yourself or easily replacing it with another gauge.
Customer
2025-06-01 12:47:45
It was as advertised
Gmag
2025-05-13 13:27:56
It did not come with replacement O rings like the description says."This fill adaptor is for 1/8 NPT thread,most commonly seen on remotes and fill stations.Will fit any bottle. Heavy duty aluminum. It includes backup orings to you, it means that you can replace the oring and use it longer."
Justin
2025-03-06 10:03:22
Valve seems great but it’s missing the o rings, something that is expressly included in the description. Valve leaks without a o ring installed, wasting my co2. Disappointed. Delaying my project. I should have read the other reviews, I’m not the first person to get shorted.
Doug Buckner
2025-01-17 19:05:08
Good part but wont work without gasket.
DEDED
2024-12-19 21:35:00
Seems to be made well, haven't used it yet.
Recommended Products
