Your cart is empty.
Your cart is empty.Product Description
Glen from Nevada
2025-08-02 18:33:39
I installed these LED turn signal replacements on my 2022 Street Glide. The included instructions were clear and in reasonably plain English - extra points for that!Important points to remember:1. When removing the rear turn signal bulbs, carefully note the positions of the lugs on the bulb base so that you can align the connectors the same way.2. If your rear turn signal bulbs have 2 contacts, use the 2 contact connector bases included with the kit. 3. Keep a careful eye on the foam tape pads in the kit - they WILL fall into the least accessible space on your bike... ask me how I know!4. When installing the connectors into the bike's turn signal sockets, you will have to press them in quite a ways before being able to turn them. I was able to do it with fingers but you might have to use pliers if your fingers won't fit. Be careful if you do use pliers not to damage the connectors!5. Pay attention to the placement of the screwdriver slots on the included lenses when you install them so that you can get to them if you need to in the future.I plugged in and tested all 4 lights before completing installation due to feedback here regarding LEDs that didn't function. All 4 sets I received worked perfectly. Then I attached the included foam rings on the front of each LED cluster but did not peel the protective layer from the side of the foam ring away from the LED cluster. That way the foam ring won't stick to the smoked lenses in case I have to remove them in future.Once installed, the LEDs are much brighter than the OEM incandescent turn signals. The front white ring running lights/center yellow turn signals worked perfectly. I did not have to let the hazard lights run to correct hyperflash, the lights operated correctly as installed. I'm happy with them but time will tell if they fail. Still a bargain at this price.
Billy
2025-07-28 11:26:44
***UPDATE*** customer service reached out to me on their own and issued me a full refund with the evidence provided. As i put in my initial review this product looks and works great, other than the one light that was defective. Looks better than Harley, the price point AND the customer service, this is a win win…..changed my rating to 5 stars bc , what else can you ask for….The nipples on the tip that lock the lights when you turn them were misplaced on one of the front lights. all the others worked great and looked great. i could have returned but really didn’t need the back lights so i just cut one of the back lights and soldered the end on. This is not ideal because i wasted money. i guess you take chances when you buy cheap knockoffs. other than that the lights look great.
FR
2025-07-04 16:46:39
Super easy to install and they look great. 2020 Softail
Angel
2025-06-21 13:51:18
Pay attention to how the tips on the bulbs are oriented when you take out the originals, they are not directly across from each other, and you'll be fine.Complete plug-and-play on the 2014 Dyna Wide Glide.Looks great with the smoked covers but rears seem slightly dimmer than stock. 1000% improvement of visibility on front running lights and turn signal. I especially like the halo light look.Took off one star for brightness, but only about the rear.Time will tell on the durability...
Kathryn Marie
2025-06-03 13:42:51
Nice bright lights, perfect fit, and easy install!!
M. Fischetti
2025-05-30 13:09:34
I bought the four bulb set really just to get the rear lights and lens set. Installation only took a couple of minutes. I opted to use the rear stock red lenses just because they are a little bit brighter then when used with the smoke lenses. Bright and high visibility is what I was going for, although the smoke lenses are very nice looking on the bike! Without syncing canbus the turn signal indicators will blink faster then the turn signals. This condition can be easily corrected using the following procedure:2014 and later.Turn the Ignition on, but do not start the bikeTurn on your 4 way hazards by pressing the hazard button on the controlsTurn the Ignition off letting hazards run. If the bike has security they will flash 5 or 6 times and then pause. This is expected. They will go back to flashing normal hazard modeLet hazards run 1-2 minutesTurn the ignition back onTurn the ignition off and then back onCheck the function of both turn signalsThese are an economical option to some of the more better know led's out there and I believe a good option. Id love to run the more expensive options out there, but these are a fraction of the cost and do a good job. Time will tell more about longevity and quality.
Customer
2025-04-18 13:10:27
They fit and work great now to see for how long.
Preet Singh
2025-04-04 18:15:30
I should have read the description. Front of 2013 FatBoy Lo are 1157, but rear is 1156. After receiving when I read the description again, it says, bikes with taillight are usually 1156. But front lights work like a wonder, super-bright, gave a new look to my denim black with smoky covers.
WonderWintry
2025-03-26 13:02:56
Front housing in my 2018 Sportster 1200 Custom comes with single contact 1156.Rear fit( only red turn signal). I think i will back to Amber (looks better).
Bruscko
2025-02-16 15:03:19
It arrived early but wirings are already damaged from the aluminium casing. Only covers I can use hence 1 star.
Daniel plouffe
2025-02-03 20:29:56
Vraiment super
Response towing
2025-01-30 17:20:56
Installed and love the new look
Recommended Products