Shopping Cart

Your cart is empty.

Your cart is empty.

Prime-Line 9071741 Lag Shields, Short, 5/8 In. X 2 in, Zinc Alloy (10 Pack)

4.9 (4) Write Review
Free shipping on orders over $29.99

$14.26

$ 6 .99 $6.99

In Stock

About this item

  • Size: 5/8 inch X 2 inch
  • Allows for lag screw bolts to be installed into concrete, brick and block
  • Inserts into a hole by tapping with a hammer until flush
  • Lag screw expands the lag shield against the walls of the hole
  • Drill hole with masonry drill bit based on diameter on anchor


Lag shield anchors allow lag screws to be installed into concrete and masonry walls. After drilling a hole into the material, lag shields should be tapped into place ribbed side first until flush with the surface. The lag screw can then be installed with a wrench or socket tool. The sides of the lag shield push out against the inside of the hole once the lag screw is installed, thereby locking it in place.


Larry L.
2025-08-30 12:43:08
Couldn't even find this large size at Lowes or Home Depot. The smaller size was more at the store than what these cost me
Mr Hersheys Mill
2025-07-18 12:14:52
These are almost exactly what advertised. However be aware that the 5/8 refers to the interior diameter and this requires a 7/8 hole. The picture shows this. On the other side is stamped 7/8 hole required
Reese
2025-06-08 14:21:24
I was able to use about half of them, they kept breaking.
tom
2025-01-27 18:18:50
Works well ,make sure you read the description for the product first then buy