Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
deo737
September 4, 2025
es lo que esperas de soportes rigidos
Agnes
August 10, 2025
First of all these mounts are apparently for the SE-R model i have a 1.8 S model Automatic. I just wanted to see if the bushing was the same diameter for the rear mount. And guess what it works...and same for the front mount...so i bought 2 of the same bushing and now i have them on.....no issue as so ever....i mean the car vibrates a little but nothing crazy...car feels way different like as in more throttle response etc etc...
Customer
August 6, 2025
I replaced front and rear engine mounts in my 2005 Nissan Sentra se-r, car drives 100% better, but you have slight engine vibration at idle
Peter T.
June 25, 2025
Fit perfect once I realized there are 2 metal rings. You have to cut out the rubber then I took the sawzall and cut from the inside out through the first of 2 metal rings, made my cut pounded the ring out now that there wasn't so much tension an boom, with a little lube it slid right in easy as pie!
Aero
May 15, 2025
The wrong instructions were included for mine. I needed the Spec V but it was for the 350z. Also it says lubricant comes with but mine didn't. Not a major complaint since the mounts fit and work really well. Just needed it to be boxed properly to leave out confusion.
dktt
March 27, 2025
As with the rear mount, used a hacksaw to cut the inner ring on the stock mount. Bent up one side and hammered a small screwdriver under the cut to split the ring and release tension. Hammered out the inner ring.New mount pressed in easily with a c-clamp and lots of grease.
ASB
March 25, 2025
These fit on the (front and rear) motor mounts for a 00-01 sentra.I put it on my 01 SE 2.0L
Gilberto
November 14, 2024
Great freaking product feels like it has alot more torque SER lovers by this product no engine rock LOVE IT !!!!
Recommended Products
