Your cart is empty.
Your cart is empty.Polyurethane based suspension, driveline and chassis components have been designed as an upgrade to the soft factory rubber components.
Paul
2025-07-11 12:56:52
My uncle has a challenger and needed these. Says they fit great and were already installed by the time I asked him if he got the package from my notification.
Ralph G.
2025-06-14 13:01:07
Good quality bushing and they work good for a challenger! Make sure to grease them up for install. ***side note for any 73/74 charger owners, these are indeed NOT for you. Bought these as an experiment to see what the difference is and these were too small so keep looking! :)
Franklin
2025-02-26 17:43:14
The important thing is to not damage the metal sleeves from the old bushings. I used a two jaw puller to push the shaft out and the inner sleeve came out with the shaft. The old worn rubber bushing was no longer bonded to the outer sleeve and peeled away easily. I used a drill end paint remover abrasive brush that fit inside and polished the outer sleeve. Wire wheeled the inner sleeve, followed the included instructions included with the small package of special lubricant for installation. Takes a very sparing amount of the lubricant to coat rubber and metal. Push the new bushings into the outer sleeve then press the shaft with inner sleeve into the bushing. Done.
arc
2024-12-17 12:30:43
Quality looks good, bought for future use, would buy again, if needed
Recommended Products
$106.16
$ 52 .99 $52.99
$18.25
$ 8 .99 $8.99