Your cart is empty.
Your cart is empty.Product Description
The Story About Us
Quickun specializes in a wide range of silicone tubes, plastic fitting, metal fittings, stainless steel fittings and other accessories.
In order to protect the legitimate rights and interests of consumers, our products from the design, production, testing, to product packaging, transportation and after-sales service all links have been strictly checked.
Thank you for your trust!
Plastic Hose Barb Reducer Fitting
Plastic Barb Reducing Adapter
Plastic barb connector barbed fitting for a tight seal on hoses. Made of high-quality Polypropylene material, no crack.
- Pressure: 125 psi (70 °F)
- 100% new and high quality material.
- Temperature Range: -22 C degree to 80 C degree ( -9 °F to 175 °F )
- Smooth surface and inner wall, lightweight and small
- The plastic fitting can be easily connected with tubing hose line.
Tips:
It is radiation stable and is good to solvents, chemicals, water and other inorganic environments. It stop most mineral acids and bases; however, it is subject to attack by oxidizing agents.
audrey61
2025-08-23 18:30:33
It reduces. Or if you are going the other way, they are increasers. Whatever they are, they work.
JP Chef
2025-08-14 09:38:30
No problems. Fit perfectly.
SPENCER R
2025-07-18 17:25:29
Sent me the wrong item at first. One of the barbs is correct but the other in the picture is not even 1/4 inch, way to small... Had to return and reorder to get correct sizes. Other than that they work well.
JAMAZON
2025-07-15 18:43:28
this worked perfect for what I needed. using for a vent hose for my gas tank.
Theodore M. Nelson
2025-06-06 11:06:26
Made to work
Auslander
2025-05-31 10:54:38
Would have done much better buying a brass connectorThe 1/4 end wasn't too bad as it was easier to tighten but the 3/16 end was loose..had to really tighten it
JohnG
2025-05-30 19:50:06
These are hard to find at local hardware stores, but if you need to connect different size hoses, they are indispensable.Just remember that the dimensions are for the INSIDE diameters of the hoses.The barbs on these adapters hold tightly without clamps.
Luis
2025-05-23 20:35:53
It works
David b
2025-03-30 09:16:04
Tel que décrit , ces good
R P
2025-03-24 18:24:22
Works good, sizes correct. Could be a bit better of a deal for two plastic fittings, 15 dollars is a bit outrageous but I can't find them in Canada for cheaper so I guess it is what it is.
Eric
2025-03-04 14:55:32
This product was not as pictured. Only one barb per side. Would not have ordered.
Colin
2025-01-14 16:28:51
Ordered the 3/16"-1/8" step down Barb fitting; the 1/8" end fit perfectly, but the opposite end was sized for a 1/4" hose. Very disappointed.
Recommended Products