Your cart is empty.
Your cart is empty.Product Description
Description
High Quality
Made of high quality cast iron with electrophoresis, this web sheave is durable, stable, corrosive resistant.
Design
With a single groove design, it can only use for the single belt.
Application
The outer diameter is 2-1/2 inches. The bore is 5/8". It can be used for V-belts in many existing drives.
M. Hocker
2025-09-04 17:52:52
Seller QWORK.Bought to replace one of the cast pulleys in a 1970s or 1980s Craftsman 113.298031 table saw. Will also need a half moon type woodruff key if the original woodruff is lost for the main body pulley (in the cabinet), or a rectangular woodruff key for the motor. I decided not to replace the motor pulley as that pulley seems in good condition; the other pulley partially slid off during operation and was slightly damaged.Pulleys are heavy metal casting, not light zinc casting, with set screws. Properly made, painted except no paint in the lumen of the pulley. Fits without problems, only some polishing of the shaft using Scotchbrite to remove fraction of thousandths of pre-existing light corrosion and old gunk on the shaft that interfered with fitment. Added antiseize to stop further corrosion and ease future removal (pulley to shaft, not to the setscrew. Woodruff key prevents rotation on shaft).These pulleys seem better made than the originals and appear better than other aftermarket pulleys. Added mass does not seem to be an issue in operation.
carlos arturo zurita lopez
2025-08-10 14:55:36
Replace my slipery a aluminum oem pulley on my old craftsman table saw
mrducky
2025-08-04 11:59:38
These are a great improvement over the stock die-cast sheaves on my Craftsman 113.298761 table saw and work great with a link-belt.
Joe Jet Ski
2025-07-07 14:59:07
Worked great on my old Craftsman table saw
David
2025-05-08 14:18:05
Got these to replace pullies on my craftsman table saw
Karen Kramer
2025-05-01 14:53:05
Came sooner than expected and was an exact fit for my old 1970's Craftsman table saw. They were an important part that helped the broken saw work. I hope to have that table saw for many more years to come.
Joel
2025-04-04 17:22:54
Pulleys used to replace my pot metal pulleys on my forty year old Craftsman 10" table saw which were badly warped. These replacement steel pulleys are much heavier, constructed of steel with a good finish which should resist rusting and were a decent value.
festes
2025-03-12 10:06:40
good
Kent Hunter-Duvar
2024-12-03 16:17:00
Replaced the original cast aluminum pulleys on my older Craftsman table saw. These are much stronger and seem well-balanced. I'm using them with a segmented belt and the saw runs smoothly and quieter than before.
Recommended Products