Your cart is empty.
Your cart is empty.Product Description
Features:
- A magnetic stand that uses a switchable permanent magnet for convenient mounting onto metal surfaces
- The arm can be locked in any position using the tightening knob
- Useful for holding dial indicators or test indicators during alignment operations.
- Permanent magnet operation with ON/OFF control.
Specification:
- Base Size(L x W x H): approximate 30 x 36 x 37mm / 1.1 x 1.4 x 1.5 inch
- total Height: approximate 200mm / 7.8 inch
- Clamping Hole Diameter: approximate 8mm
Notice:
- Please pay attention to the Specification of it before purchasing.
- Please also make sure it fits for your Indicator.
Package:
- 1 set Magnetic stand
Tanara Petrova
2025-08-04 18:07:13
I was a little worried at first because it's a bit small compared to my old one, but it holds on at least as strong and the single knob to stiffen the arm is perfect for making sure everything is lined up well.
Rose 666
2025-07-16 15:46:12
For how much you end up paying this is a Nifty little holder. If it were any expensive I'd say the bill quality was inadequate but realistically it does this job well at the right price. The ball joint at the end that attaches to your dial indicator is a little rough but that might be fixed with some polishing or something if you want to get into that. The magnet is strong enough, won't go anywhere unless you move it but I wouldn't trust it with anything too heavy.
Kindle Customer
2025-07-15 18:51:33
It's a small indicator stand which is handy to get into tight places. I would purchase it again.
Educated Consumer
2025-07-13 13:38:39
This thing saved my life when aligning a bellhousing. It's very small and did the job perfect!
matermark
2025-06-15 16:14:43
This was very cumbersome to use, it seemed sloppy and even floppy, just not easy to set or adjust. It was quite disappointing to see, it seemed much smaller than you thought it would be... No, seriously, I'm describing a dial indicator base. Really! Give me the old style with a solid base rod. The only thing to like about this was the red anodizing.
Marv Bros
2025-05-05 12:58:17
Easy to posistion because when relaxed, the arms move together.
Asktoro
2025-05-03 10:33:54
It did its job, the magnet is a bit eh, but otherwise it works and holds the dial indicator stable, also doubles as a 3rd hand if you put an aligator clip on it which works waaaay better than your typical 3rd hands.
Phil Williamson
2025-04-08 14:57:25
I had to return the base because the magnetic contact area was not machined correctly. The base appeared to have been "machined" on a belt sander. It was not flat/square. When the magnet was engaged the base would rock back and forth, it would not hold consistently. The articulating arm, however, did work correctly. It would have been a good product if it had been correctly made. Apparently there was no QC or inspector at the factory.
Dam
2025-01-30 16:16:03
Même pas 1 jour, il s'est complètement gâté
Yasaman f.
2025-01-22 11:41:45
This is way too small and doesn't work with standard dial indicators.
Recommended Products
$57.04
$ 25 .99 $25.99
$28.08
$ 11 .99 $11.99