Your cart is empty.
Your cart is empty.Product Description
Pure copper
RED WOLF wire harness adopt pure copper, Strong conductivity, Safety and reliable during use.
- Cold tolerance-40℉
- High-temperature 221 ℉
- Abrasion resistance
- Strong malleability
SlippyFist
2025-09-01 15:43:46
Dropped this in a 2005 Wrangler TJ with a new Kenwood Excelon KCD-X305 head unit. If you're using the *factory* amp, make sure you hook up the solid blue wire (usually labeled as Power Antenna) to the blue wire with white stripe that comes from your head unit that will be labeled for Continuous Power- otherwise your sub will not turn on. If you have an aftermarket amp, it will have it's own C Power line that hooks to the one from the head unit.
Gary L. Heitzmann
2025-08-28 21:45:43
I have an 07 2500 with stanard stereo, no wheel controls, no amps. This works great 👠you MUST run a 12v key supply wire. Your Dodge has 2 12v battery connections but not a 12 v key on. I just connected to the cigarette lighter which is key switch on. Everything else aligned, speakers etc. The small plug i just left undone from the factory unit. Pci bus stuff.
Breann Baumann
2025-08-25 11:37:37
Perfect fit on my 2006 dodge ram 2500. After so many years of running my stock radio, I finally upgraded to a double din and this part was just what I needed. Colors matched perfectly and was an easy DIY project. Lots of videos out there if your get confused.
GrouperMan
2025-08-19 13:56:06
THIS WILL NOT WORK IN 2006+ RAMS!!! CRUCHFILED CONFIRMED DODGE CHNAGED THE HARNESS IN 2006. I AM NOT THE ONLY REVIEW AND WISH I SAW THE OTHERS. UPDATE YOUR LISTING. NOW WE HAVE THE WHOLE DASH APART AND HAVE TO ORDER ANOTHER HARNESS OR DIRECT WIREPS OWNERS: The correct harness is $59 (no way around it). It is not hard to direct wire aftermarket head unit. 30 minutes and a wire splicer with butt connectors. google the radio wire schematic if you do not have the service manual. Or just use common sense....the 4 speaker's color wires match. Two grey with red strip on the end are constant power...splice together (they are the same) and connect to aftermarket radio's constant power (usually yellow). ACC Power (red) to Radio ACC power. Done!
matt
2025-07-28 09:50:52
Generic and does not match the inputs on my 06 commander. Had to make due.
JONATHAN
2025-07-05 18:36:55
If your color blind this is what you want all the wires are labeled so you know where they go unless your radio is not labeled then you might be screwed but if you just follow the wire diagram on your radio I'm sure it's going to tell you what wire goes where wires are made pretty thick it's not cheap it's just snaps right into the to the vehicle and it's done quick simple easy I would buy it again if I had to
Kelly Winther
2025-07-01 19:37:14
So this says it doesn't fit a 2007 Aspen but the one that said it did, didn't which sent us on a search for ones with the right plug. This one "fit" but the wires were not to the right things if matching color to color. For a 2007 Aspen, we needed a really expensive one that would work with Boze speaker system. If you have gone through trying several of these harnesses and none are fitting, call Car Toys and ask them which harness it says ..they found it quickly and installed it for us. Also the stereo I had purchased was a buzzing so we got a slightly more expensive stereo to have them install.
Timothy Ehmke
2025-05-06 10:25:37
Not for the 2006 Jeep commander
Customer
2025-04-20 15:44:24
Fit on a kenwood deck going into a 2004 dodge srt4. Instructions were clear, appears to be good quality. Radio works as needed
Juan
2025-02-23 12:57:39
Funciona en jeep compass 2007, solamente no no fue compatible con el cable rojo de corriente al abrir el switch, asi que lo tuve que conectar al cable amarillo de corriente de bateria, ese y el cable de iluminacion no se encuentran, solo ese detalle tiene pero puede ser por que el estereo original es sencillo y no es una pantalla como el que le acabo de instalar
Michael Hamm
2025-02-06 15:29:54
Works well on a 2007 Dodge Ram. Mine did not use the brown, blue or pink wires so I just cut them off. Because the factory radio gets its power supply from elsewhere in the truck harness, you will need to find a power source for keyed power. Mine had the harness for seat heaters, but I have no seat heaters, so I just tied into that. Others will take their keyed power off the cigarette lighter, but for some reason, both my cigarette lighter and my in dash power receptacle were on constant power. So you basically only use the ground wires (tie those together) and the Yellow wires for power (tie those together), and then the 8 speaker wires. Then, take the red wire from your radio and hook that up to a keyed power source directly. Easy Peasy.
Crown Royals
2025-01-29 10:57:25
Worked as described
Yorniloc
2024-12-20 19:25:10
Item arrived used. Looked like it was cut out of a vehicle, no fm adapter. Would give 0 stars if I could
Recommended Products