Your cart is empty.
Your cart is empty.Black rubber strap handle with black fittings. Great for handling any speaker enclosure. Easily mounted.
Joe Bouler
2025-08-21 18:13:04
No frills handle. Very strong and priced right. Flexible metal encased in rubber. Perfect replacement for my guitar amplifier. There's nothing to dislike about it. It's very functional. What you see in the picture is what you get. It does not come with screws included. I bought it knowing that, but another reviewer on a similar handle whined about not getting screws with his handle and claimed it was useless to him because he didn't get screws with it. Poor fellow, I suppose his local hardware store is all out of screws. Be sure to install it with both metal ends up against the outward ends of the handle. That way you have slack in the handle to get your hand under it and the handle will lay flat when not in use.
Josh H.
2025-08-02 17:30:59
Affixed to my homemade pedal board as a carry handle. Sturdy and works great!
Charlie
2025-07-14 18:10:03
Great
Customer
2025-04-09 21:29:57
Though this handle is designed for wood box type electronics such as guitar amps, I purchased it to mount on top of an all metal heavy lab power supply for ease of mobility. The metal tabs (covers) on each end of the strap, which are designed to mount with screws and dig into the wood of an amp to prevent swivel, were an issue for my application against bare metal. This is to no fault of the manufacturer as my application is not what this strap was designed for, however, this was overcome when I cut two patches of thick nylon and placed them between the straps tabs (covers) and the metal power supply housing. This provided something for the tabs to grip into as I tightened my screws.The handle is heavy duty rubber (vinyl) and well made. It is designed to lay flat when not in use, but when grabbed will flex open (up) providing space to grip it. This is a well made product at this price point.
Jeremiah A. Shifflett
2025-04-03 18:14:34
this is 1 tough strap I put one on a case that weights 120 lbs and it doesnt even flinch!
edmondsonsound
2025-03-28 12:33:18
should be cheaper but it works easy to mount and very strong but make sure your screws are deep enough
R. J. Crane
2025-03-22 10:45:34
Not as pretty as the original, but it works!
Zenhigh
2025-01-12 11:58:40
I screwed up a bit fitting it, should have paid more attention to slack requirements.You need to measure twice screw once ( I used bolts and tee nuts so I won't be adjusting).
Recommended Products
