Your cart is empty.
Your cart is empty.High Quality Mini Switches made in Taiwan
Benjamin H. Mossberg
2025-09-06 15:14:20
They seem well made, solid click action. I’m confused why they come with keyed washers.
Mark A. Green
2025-09-05 14:03:45
I used one of these switches to coil tap a humbucker I installed in the bridge position of my strat. It works flawlessly time will tell about the quality and longevity of this switch but it seems to be a well made part. For the price it was worth trying out and so far I am happy with my purchase.
Mr. N
2025-09-02 14:02:35
I purchased these switches to let me individually split the coils of a set of Wilkinson humbuckers I installed in my Mustang project guitar. The Mustang doesn't have a ton of room on the lower horn cavity, so these were the perfect size. The throw is crisp and I was pleased to see that a lock washer was included along with the nuts.amd surface washer. I was considering just splitting both with a single switch, but as soon as I saw how small they were, I went ahead and installed two. Great price on quality switches.
JustAskJAK
2025-08-31 15:55:42
I bought these (3 pack-mini DPDT on/off/on) to use in a double neck bass/6 string guitar that I built with tone circuits for each of the two outputs. First issue is that one of the 3 switches was the wrong product (on/on), and the other is the other 2 malfunction after a couple months of use. They crackle and pop and don't make complete continuity and short out.
Dane dellapenta
2025-08-13 15:47:25
Poli how did you wire this to series parallel split I have ran through every configuration I can find I haven't seen a switch with this configuration before I know there are 2 types but the ones I received are not like any of the two common ones if anyone can help please comment otherwise the shipping and quality of the product was excellent.
Avalanche man
2025-04-23 13:28:55
Buy them they work great! Make sure you order the right ones they can be tricky, as in on/off, or on/off/on or off/on/off lol
Peter Langston
2025-04-22 18:06:59
These small DPDT 6-contact switches are nice, and I would have given them 5 stars, but only one hex nut is provided for each switch meaning the long threaded collar will stick out of any panel they're mounted on.In the same order I also bought a set of two small DPDT 6-contact switches along with a large DPDT 6-contact switch from the same vendor (Salecom) and those switches did come with 2 hex nuts for each switch. I expect it to be difficult to find other hex nuts to fit these switches.
Mark C.
2025-02-01 11:00:05
Great little switch. There are two types of On/On/On switch: Check to be sure you have/need the configuration you THINK you do. ;)Good build (don't overheat!), great price, on-schedule delivery.(Tip -- if you have to connect-and-jump a wire (across terminals), try this: strip the wire so it's naked for the full run between the terminal posts, solder the first leg [right where the stripping *ends*], then clip a little off the stripped/discarded insulation [to leave room for the solder joints at each end] and slip it back on the previously-stripped end protruding from the just-soldered lug (easier with solid than stranded wire), optionally with a little shrink-tubing, then solder the other end of the "jump," and just clip off any extra. Voila; ONE wire to solder into that little hole instead of two, and no naked wire to short out. [The shrink tubing often shrinks from the transmitted heat of the soldering alone with only some hot-air touch-up needed for the 'cooler' end])
Recommended Products
