Your cart is empty.
Your cart is empty.Product Description
3D design:The clear Anti-Slip stomp pad features a 3D raised design,Increase friction, effectively improve skid resistance, provide maximum grip and traction.
Package include
You will get 2 sets of different snowboard stomp pads, suitable for your winter snowboarding.Enough for your daily use and replacement.
Made of high quality PVC material,strong and durable, not easy to fracture and deformation,can effectively scrape the snow on your sole. Add more fun to your snowboarding trip.
eden
2025-08-11 19:30:45
This was prefect for my snowboard. As a beginner, this helped me be less clumsy because it created some friction so my boots stopped sliding as much when getting off the chair lift. However, I am still clumsy, and I accidentally fell and my knee got a gnarly bruise because I fell onto the stomp pad while lining up in the queue. Overall, effective and would recommend for beginners if you have not installed them on your board.
Alyssa
2025-08-05 15:40:55
Absolutely terrible product I wish I could give it 0 stars. It doesn’t stick to my board at all. I ended up just riding without it. Don’t buy unless you wanna waste your money
Patricia C
2025-07-06 09:52:51
Wiped board with alcohol, placed these on as needed, tossed a weight on there to press it down. Adhered 100%, took boarding this year, no movement, no issues. Would recommend. The two patterns were nice to so gives some level of choice on how you want to configure. Good deal
Matt Mullen
2025-06-30 13:28:00
Great quality, good stickiness. Wish they were a little sharper but does great coming off the lifts
Ekaterina Morozova
2025-06-19 16:09:54
Good quality
Lytain Lee
2025-03-23 14:03:38
The bottom pad was peeled off after very 1st ride on the snow. The sticker was not very strong.
MikeS
2025-02-19 14:10:58
Ok. Step one : clean area on board with alcohol based cleaner. Step two: get everything nice and warm, use the wood stove , the hair dryer etc. Step three: use as much of the sticky tape as possible. The die cut leaves a lot of gaps on the edges so water can get under it, then freeze and pop it off. I used a pair of scissors to trim the whole size of tape to the stomp pad. Last step: pressure. Step on it. Hard for a minute or so. Keep it warm overnight.
JoSo55
2025-02-15 16:02:41
The adhesive stickers are junk and didn't hold, so I used a different adhesive glue and they work great
Recommended Products