Your cart is empty.
Your cart is empty.Product Description
Installation Instructions:
1. Remove housing and/or shifter from vehicle
2. Remove old bushing from housing
3. After removal of bushing inspect inside diameter. Clean if necessary
4. Align bushing cross hole with cross hole in housing (Note: Pre-alignment marks on bushing)
5. Press bushing into hole until aligned. If needed a slight amount of glass cleaner or soapy water can be applied to bushing O.D. and inside of housing to help installation and alignment
6. Using supplied fasteners and illustration above make sure bushing thru hole alignment is correct prior to installing into vehicle
7. Install components onto vehicle and fasten securely
Replacement Part Numbers
ent Part Numbers（更换部件号）
Replace MS99-63399
High-quality Materials
The shifter isolator bushing kit is made of high-quality polyurethane rubber, which is strong and durable, aging slowly
Perfect Replacement
Shifter isolator bushing kit are 100% quality tested before leaving the factory, with stable performance
Fred
2025-08-28 16:13:59
Gear shift tower in a international
AmHoff
2024-12-12 16:01:06
The threads on the bolt is deformed on the end so the nut will not start. And the diameter of the bolt is too big for the hole in the shaft.
Randy
2024-12-04 14:14:22
It’s amazing installs by hand
Recommended Products