Your cart is empty.
Your cart is empty.EC2GB series ground bars are intended for use in Siemens ES and PL series of load centers with a box height of 18, 21, 23, 24, 27, 30, 35, or 36 inches. For the ES and PL lines of load centers this would include up to 200A load centers that have 40 1-Inch circuit spaces or less. The ground bars can be mounted in one of 4 locations inside the load center: top right, top left, bottom right, and bottom left. Up to 4 ground bars can be added to each load center.
S. Max
2025-08-14 15:09:25
It's been some years since I did electrical work, but before, the panels all had ground bars and neutral bars, if it was the main panel, you used the included screw to tie the 2 together. Now it appears you have to buy the ground bar separately since a sub-panel has to have separate ground/neutral bars. I used this in my Square D panel, it had the big lug already bolted on. I did drill two 1/8 holes for the screws to mount the bar since I wanted it where I wanted it, not where some pre-drilled holes were in the panel.
Chip
2025-06-23 16:40:35
I have installed these, tightened the screws to secure the wires, then took everything apart and started over. Nothing stripped and nothing loose. This is a good quality ground bar. This is much better than the one that came with my expensive main panel (breaker box). I need components which are durable because I install them into RVs, campers and buses. People refer to these vehicles as “earthquakes on wheels†as everything inside and out are shaken and jostled for thousands of miles. I need products that can withstand the abuse. This ground bar will hold up just fine.
Craig Keller
2025-05-06 13:59:31
Worked perfectly. Installed with ease!!!
Andrew
2024-12-27 14:48:40
couldn't find one of these at the big box stores in my area so I bought one on amazon. It was delivered in a few day's and works great.
francis gagnon
2024-12-02 16:14:04
tres bien
Recommended Products
