Your cart is empty.
Your cart is empty.This wood thread cutting kit will effortlessly cut strong, tight fitting 1-1/2 inch x 6 TPI male/female OD/ID threads in wood for use in vices, clamps, toys, furniture, puzzles, fixtures and more. The 1-1/2 inch tap requires a 1-3/8 starter hole (drill bit not included). Straight-grain and round hardwood dowels work best. Oil dowel with mineral or boiled linseed oil (not included), or better yet, soak dowel in oil for several days before machining to reduce friction and tearout. The two-handled threadbox cuts the male threads . Polypropylene threadbox includes ergonomic 2-1/2 inch long x 1 inch diameter turned handles for secure and easy gripping. Threadbox has aluminum inserts to prevent excessive wear. Designed to allow easy chip clearance. The matching tap die cuts the internal female threads. Hardened 1-1/2 inch x 6 TPI hardened steel tap is machined to close tolerances. Tap is designed for through holes. SPECIFICATIONS: Threadbox overall size is 10-1/2” long x 2-1/4” wide x 2.4” high: hardened high speed cutter (available separately) designed for chip clearance; 1 inch diameter by 7 inches long tap designed to produce 1-1/2 inch x 6 TPI threads. Package includes Polypropylene threadbox, 7-inch through-hole tap with handle and instructions.
Alpheus W Blizzard III
2025-09-02 13:08:18
Tool works flawlessly! Even going through Maple whish is a tough wood.
Sam Arnold
2025-08-01 11:39:19
was shipped timely... Product was as stated, quality build.
caffeineacademy
2025-04-23 16:47:37
Taytool has products that are affordable and high quality. I am not a habitual reviewer but after several Taytool purchases I think its time to let people know .
Jerry T. Laand
2025-04-15 15:05:21
excellent,speedy service
Christian Moussa
2025-03-01 19:34:13
I purchased 1-1/4" and 3/4" sets.TAPS: The taps worked okay for a few nuts but started to blunt despite frequent oiling before and during use.DIE BODY: The plastic body of the die will warp, and in multiple areas. The area that holds the blade will skew. The threads will not come out symmetrical once this happens, and no amount of shims will adjust the blade correctly. This means that even if you thread the dowel, it will not fit in the nut.DIE BLADE: I soaked my dowels in oil for 1 week prior to using the die, and I ejected the chips by regularly rotating a 1/4 turn backwards as instructed. Despite this, the blade on the 1-1/4" broke on the FIRST use. I managed to use the 3/4" to thread a few feet of dowel over a week before that blade also broke. I ordered a replacement blade thinking I could try and get the 3/4" die to work again, but the skew in the plastic makes it impossible to adjust accurately.DIE HARDWARE: The bolt that holds the blade in place is made of brass. It bent on tightening making it unusable to hold the blade in place. If its not tightened, the blade just glides backwards.CONCLUSION: This is not a tool, this is a money pit. Don't buy this.
Eric A Feltz
2025-01-12 10:04:11
Works well, I had a 3/4 in set that I use as well, dont be afraid to dip your dowel in mineral oil, which will assist in the cut and quality. Run the tap several time thru the hole to free up a tight fit. Be careful not to cross thread
Customer
2024-12-01 13:39:57
Worked better than I thought. Excellent
Recommended Products
