Your cart is empty.
Your cart is empty.Material is case hardened 1018 steel with black oxide finish. 1/2"-13 Thread. 5/8" Table slot. 1-1/8" Base size. Measures 5/8" width by 1" height.
vadym
2025-08-29 18:12:15
5/8 slot T nut for milling machine table has very good quality all around! Fits my RF-30 and RF-31 milling machines like a dream! I measured:The part which goes into slot is 15.3 mm wide, the bottom portion of nut is 25.7 mm wide. My RF-30 mill has table slot 16mm and bottom portion is 27mm so,These 5 nuts are PERFECT! I really didn't care about threads bks today, you can get any bolt or threaded rods from any store and cut it to your needs.They are beefy, will hold any vise, tool, work peace.
Old Goat
2025-08-07 14:06:38
Very nice, no distortion around the tapped holes, clean finish on all the sides, the ends show some cutoff marks, but now I am nitpicking. There is not much room to impress as a lowly T-slot nut, but these do look better than I would have expected. Makes me want the full machinists set
Victor K
2025-08-04 18:14:15
Perfect fit and very well made.
KEO
2025-06-01 11:57:37
They work great on my 17†Grizzly drill press!
M. J. Reinsma
2025-04-12 18:21:27
Fits like a glove as long as you measure cirrectly
Old Sarge
2025-02-17 17:13:30
It Works
andrewwynn
2025-02-11 17:55:46
Hard to find grade 8 and through hole. Many of these are made to bind to protect a raw table but I'm using in a different way (to add permanent mount to bottom of a truck bed)
Ray Wimer Jr.
2025-02-04 13:36:44
Works as expected in my Bridgeport mill.
Rebecca Richards
2025-01-24 15:56:52
Fits Tacoma bed rail perfectly, nice and snug.Had to remove first torx 30 bolt to get it in then just pull them away from the back as you need to pass by others in the rail
restless.studio
2025-01-03 10:13:44
The parts are nicely done and the threads are clean and fit the 1/2in thread nicely.A bit in the pricey side, but worth the investment if you dont want to make those yourself.Furthermore the 5/8 size fits perfectly on the bridgeport table.
André laliberté
2024-12-24 18:44:49
Need extra 5/8 t-slot nut for my vise on my milling machine and they fit perfectly for my PDM-30. I didn’t want to use the t-slot nut that came with my clamping kit. It is always useful to have some extra anyway.
Big T
2024-12-03 17:22:42
Nice T nut what can I say….
Stephane Jean
2024-11-27 15:35:11
fit perfect in grooves, machining is with no fault. The bolts screw in easily.
Recommended Products
$23.99
$ 11 .99 $11.99