Your cart is empty.
Your cart is empty.Product Description
Product features
The probe tip diameter is only 0.2mm, and the hard and thin tip is suitable for measuring tiny IC pins, LED lamps, and small components
Wide range of applications
Precise measurement
It is suitable for precision narrow scene measurement, easy puncture of thin gauge needles, small measurement of wire harness damage,
OBD automotive on-board diagnostic system
Compatible with a 2mm multimeter stylus, it is easy to connect and facilitate measurement in precise and narrow scenes
Rigid Back Test Pin Set
2'' Long Pins Pass Between The Weather Pack Seal and Wire
A Sharp Point Ensures Good Contact To the Electrical Connector, and The Pin's
Insulation Protects It From Shorting to Other Wires
Slides Onto Test Probes Measuring 2mm ,Tested to 60VDC
Pattern Name:TP88A
Brand : ZIBOO
Model: TP88A Red+Black
Rated Voltave:CAT II 600V
Rated Current :10A Diameter:Φ2mm
Better than a test probe alone ,
These two inch long rigid back probe pins easily pass between the weather pack seal and wire.
A sharp point ensures good contact to the electrical connector,
and the pin's insulation protects it from shorting to other wires.
Customer
2025-08-13 10:21:25
it does the function as expected. good product. used it for checking continuity and voltage on a car diagnostics and was very helpful.
REW
2025-08-06 18:10:00
Fit Snugly on Klein CL445. I was worried about fitment because I'm not used to using add-ons like this on my multimeters but these fit perfectly
Vicente
2025-06-14 12:13:42
Good quality, should have got long ago, very handy to get multimeter leads into pesky connectors and the like. I use it often and looks relatively durable. Not flimsy. Was not expecting more than this.
James R.
2025-04-15 10:15:21
I have a standard Fluke multimeter and the fitment of these needle probes are nice and snug.The plastic sleeves also fit perfectly around the molded handles of my test probes. The needle tips are small enough to fit into automotive plugs. Note that the tips are exposed, but the rest of the needle shaft has a black coating; this coating is non-conductive. I would have given these 5 stars if the little rubber covers they include weren't so easy to lose (they are really small and have no tether to secure them).
Michael 62
2025-02-05 12:23:25
Works great!
james richardson
2025-01-15 14:33:07
Perfect 👌 just what I needed to troubleshoot a problem on the truck without messing up the pins. Just slip it in past the wire and didn't have to touch the pin
Projet2907
2025-01-03 15:20:49
Fits on my 2mm Multimeter probes like it says in the description. It went very well to test tight places like my RV Atwood water heater.
mikael romanoff
2024-12-17 12:01:33
Decent at best. I know I’m rough on tools but they are rather flimsyCheap? Yes. And it shows
Recommended Products