Shopping Cart

Your cart is empty.

Your cart is empty.

TWAYRDIO NMO Dual Band Antenna, 144MHz VHF and 430MHz UHF Two Way Antenna for Motorola Kenwood Icom Vertex Blackbox HYT Hytera Mobile Radios, Requires NMO Mount

Free shipping on orders over $29.99

$25.99

$ 12 .99 $12.99

In Stock

About this item

  • [Mobile Radio Antenna Frequency] The antenna features VHF UHF of 144/430 MHz (136-174MHz and 400-470Mhz) with VSWR less than 1.5.
  • [Great Specifications] The antenna features great specifications with vertical polarization and gain: 144MHz (3.0dBi), 430MHz(5.0dBi) for better TX and RX. The maximum power input is 100W along with impedance ranging 50Ω and omni radiation.
  • [Premium Material] This 20inch or 51cm tall antenna is composed of stainless steel making it durable and lightweight with a weight of 160g. The NMO mobile transceiver antenna requires no tuning.
  • [Compatibility] The two-way antenna is compatible with VHF UHF Motorola Kenwood Icom Vertex Blackbox HYT Hytera mobile radios.
  • [What You Get] The TWAYRDIO package contains 1*dual band NMO antenna that is professionally tested and 1*small L-type installation tool. Please note that the NMO magnetic base in not included. If you run across any problems or issues, please feel free to contact us.



Product Description

TWAYRDIO Dual Band NMO Antenna Compatible with Motorola Midland 2Meter/70cm Transceiver

dual band nmo antenna

The TWAYRDIO antenna features a frequency range of 144/430 MHz (136-174MHz VHF and 400-470Mhz UHF) with VSWR:< 1.5 which is carefully planned and developed to make sure, you receive great transmission over many uses.

The TWAYRDIO dual band NMO antenna is compatible with VHF UHF Motorola Kenwood Icom Vertex Blackbox HYT Hytera mobile radios.

nmo antenna base

NMO Connector

Inner diameter is approximately 1.1 inches, outer diameter is approximately 1.5 inches.

Premium Material

Premium Material

This antenna is composed of stainless steel making it durable and lightweight with a weight of 160g. Antenna requires no tuning.

Easy installation

Easy Installation

Easy installation by rotating the two screws of the antenna base with the L-type installation tool.

The antenna is suitable for mounts or coaxial cables with NMO connector.

Compatibility

The antenna is suitable for mounts or coaxial cables with NMO connector.

Electrical Specifications

Frequency Range 144/430 MHz
Maximum Power Input 100W
Gain 144MHz (3.0dBi) 430MHz (5.0dBi)
Impedance 50 Ω
VSWR <1.5
Polarization Vertical
Radiation Omni
Lighting Protection Direct Ground

Mechanical Specifications

Height 20 inches
Antenna Connector NMO
Weight 160g
Radiating Element Material Stainless Steel

Customer
2025-08-23 15:49:46
Attached to my Jeep using a fender mount that was designed for a tight clean installation - looks great! SWR was amazingly low without any tuning for 2m and 70cm, too. Started put with the whip bottomed out and checked the SWR and it was no higher than 1.5:1 on 70cm and 1.2:1 on 2m. Broadband response, too. Checked with DMR repeaters 20 miles out and worked excellent with my radio. Highly recommend!
LGS
2025-07-31 12:23:20
I used a Larsen 270 antenna for nearly a decade. It worked very well, but lately started giving a bad SWR reading. I found this replacement and so far I’m very happy. It is made very well and radiates well enough to get into the repeaters around LA. I like the fact that the whip is shorter and stiffer than the 270, therefore less likely to hit when going through a parking garage or loosen on very rough road.
Tom Jag
2025-04-15 12:54:42
Antenna was a little long had to take off about 3/16 of an inch to get a good SWR match on 2m & 70cm bands. I am using a permanent mount not a mag mount it is attached to my roof rack side rails and grounded. Works Good!
Paul H.
2025-04-14 11:54:32
This antenna was an absolute steal. It works as a tri-band antenna. 143-147mhz 1.2 swr, 443-446mhz 1.4 swr and 467mhz was 1.6 swr. Measurements were checked on a Rigexpert and mounted with on a Bulletproof Diesel 3rd break light NMO mount. I utilize Ham 2m/70cm frequency’s as well as GMRS. This antenna feels pretty durable and sits at 21” in hight. Im connected to handheld radio with 5 watts and hitting all the repeaters in my area. Before my transmit signal was not very clear from inside the vehicle. With this antenna I’m getting good feedback on my clarity. Im very happy with this purchase. I was leaning on getting a Scan-III for much more money. Dont be hesitant about the brand name or quality. This antenna will work.
John Doe
2025-03-03 16:20:54
Worked great. Didn't have to make any adjustments.
RallyWgn
2025-01-26 12:01:54
I live in the Hudson Valley/Catskill region of New York with a lot or hills and mountains. I wanted to try a quarter wave antenna to see how it would do against my Comet SS680SB. I must say, it out performs the Comet down in the low spots hitting repeaters where the 680 doesn't due to the radiating angle. SWR is near perfect on VHF 2 meters and MURS, fair on 70cm, and still usable on GMRS. I had to remove an inch and a quarter off the whip to get the SWR down on UHF. I may take another quarter of an inch off to see if it helps with GMRS, but I really only use 2 meters/70cm and MURS so I may let it be. I just hope the antenna holds up long term.
Kim
2025-01-03 18:55:48
Good dual band antenna for the price
Matt M
2024-12-21 15:54:26
Overall good, especially for the cost. Initially the SWR was about 1.6:1 on 146MHz and 1.3:1 on 430MHz, and 2.6:1 on 440MHzAfter a few cuts taking 1/4"-3/8" off at a time with a hack-saw it got substantially better. I unfortunately went a bit too far but not by much. I think I took about 1 inch off (wish I stopped about 3/4" removed) and now it runs around 1.3:1 on 146MHz, 1.0:1 on 430MHz, and 2.3:1 on 440MHz.For the cost, I'm reasonably happy with the results.
Recommended Products

$21.60

$ 9 .99 $9.99

4.4
Select Option

$9.99

$ 4 .99 $4.99

4.5
Select Option