Shopping Cart

Your cart is empty.

Your cart is empty.

Universal Motorcycle Kill Stop Switch Horn Button Motorbike Switch Handlebar for ATV Dirt Bike 7/8inch 22mm (Pack of 2) (Red)

Free shipping on orders over $29.99

$8.99

$ 3 .99 $3.99

In Stock

1.Color:Red


About this item

  • Switch Size(Approx): 27x32x22mm/1''x1.3''x0.87'', Wire Length: 55cm/20.08'', Install diameter: 22mm/0.87''
  • Universal handlebar design and suitable for most motorcycles, ATVs, scooters, or snowmobiles.
  • 7/8 inch motorcycle handlebar horn switch can be used as horn switch, start/stop switch, overtaking light switch
  • Can be used as an on/off switch as horn switch, start/stop switch, overtaking light switch, and power sockets switch for mobile devices.
  • The 70cm wire can be installed anywhere on the motorcycle. With two 3.5mm bullet connectors, easy to install



Product Description

mini bike kill switch

Kill Stop Handlebar Switch Horn Button For Motorcycle Bike Quad ATV

  • This kill switch will fit most bicycles and is very easy to install, fits 22mm handlebars with suitable straps, suitable for all-terrain vehicles, quad bikes, trolleys, bicycles, cross-country motorcycles, etc.
  • The bottom of the shell clip is separated for easy to hook up.
  • There is a rubber sleeve sealing around the termination button to prevent the switch contacts from entering dust, water, and moisture.

SPECIFICATION

Switch Type: Motorcycle Handlebar Kill Switch
Material: ABS
Controller Type: Push Button
Actuator Type: Push Button
Size: Handlebar Mounted for 22mm (7/8) bars
Operating Voltage: 12 Volts
Package Included: 2PCS Pit Bike Kill Switch, Mounting hardware is included
Application: Can be used as a horn or start switch as well.
Installation Tip: One wire goes to earth and the other goes to your Bike ignition coil earth, once pressed it sends the bike's coil to earth cutting the power.
handlebar kill switch

Lori Kay
2025-07-29 16:53:02
1st bought 'em just to replace weather rubber button seal on my 200 KTM, them bought 'em again to replace the fancy one piece start /kill button on my Beta, to get start on right and kill on left like I'm use to. Rubber seal is holding up as good as OEM and function is swell. Also used one to get rid of the toggle/ kill switch (the grand son had enough trouble kicking it over to waste the kick because the switch was toggled off) just use a push button to kill the engine.
Nodramamomma
2025-05-11 15:50:01
Does the job good price
Oscar Andres
2025-04-14 15:46:29
El dispositivo es de precio accesible y buen aspecto. Para confirmar su calidad habrá que esperar algún tiempo de uso. Sin embargo y antes de instalarlo ya se pueden anotar al menos dos puntos donde el fabricante tal vez debería mejorar un poco y se ganaría la 5ta estrella:1.- Al retirarlo de la bolsa para examinarlo, se desarmó de inmediato ya que las dos partes que componen la carcasa se sujetan mediante dos dientes que tienen poco poder de agarre. Resorte y disco de contacto salieron disparados y hay que tener pulso de relojero para volver a armarlo. TIP: para el usuario que lo compre será buena idea poner un par de gotas de pegamento de metacrilato en el borde entre ambas piezas de la carcasa2.- Por la parte inferior, la que haría contacto con el manubrio de la motocicleta, los dos terminales no están aislados, será necesario cortar un disco de cinta pvc aislante y fijarlo sobre los mismosSon dos mejoras que podrían implementarse en fábrica casi sin costoEstéticamente podría mejorarse el forro de los cables poniendo material termocontraible, el par de interruptores que me entregaron tiene un precinto de color negro para evitar que el forro de deslice sobre los cables. Funciona pero se ve demasiado artesanal.El botón pulsador se siente firme y la prueba con tester digital muestra que funciona correctamente (posición normal: circuito abierto, tal como se necesita para una bocina).
Shopper
2025-01-11 13:33:32
Built pretty good, came with all hardware, looks good too. Works as intended.
Mason
2025-01-09 21:48:01
Gave it 3 stars cause one of the switches was not working fresh out the box luckily the other one worked fine
Nate
2025-01-07 12:47:56
For the price, it's good. Bought to use as a reverse button and it was an easy install.
J P.
2024-11-28 17:47:41
I'm using this as a start button on a 2003 yahama big bear 400 4x4 and its flawless so far. The mounting bracket works well and the button is snappy and clicks well.
William Ramos
2024-11-19 10:53:33
Worked as intended