Your cart is empty.
Your cart is empty.Product Description
Easy Operation:
Step 1: Solder the IC socket to the PCB circuit board.
Step 2: Insert the chip into the IC socket, finish.
The IC socket is the carrier between the chip and the PCB circuit board, the chip can be pulled and inserted directly without soldering to the PCB board.
Noted:
The spacing and line spacing of the connector holes must be the same as the spacing and line spacing of the chip pins.
Advantage:
When you need to install or replace the chip, directly remove the connection between the IC socket and chip, achieving the effect of saving IC cost and time.
Feature:
Great electronic component for PCB board, IC socket has strong heat resistance, it can withstand repeated welding and disassembly without damaging the chip.
Brad
2025-09-04 10:04:53
Product is as described
NathanDean
2025-09-02 10:46:50
No pins were bent great buy
DaveG
2025-07-09 10:45:22
I needed a couple of these quickly and the price was right, but I should have gone with my usual suppliers and just waited. These came in a baggie that looked like it had been through the ringer and the thin pins were pretty bent up. After installing one, I found it to be difficult to properly insert a new chip. I made it work, but I’ve learned my lesson.
Customer
2025-06-13 15:31:33
I bought these to use with a breadboard, but they pop out. The chip stays in the breadboard better without this socket. I only kept them in case I use them on a PCB, which they seem ok for.
John H.
2025-05-04 14:55:13
Works well, solders well.
Mel Beckman
2025-02-06 16:19:37
Great for lashing up semi-permanent projects! Quality sockets.
twitheadtwitting
2025-01-10 10:20:06
They are good for the price….fitted boards nice an soldered up, no problems. A plastic socket that takes a 16pin ic chip, that all slotted in well. I would buy again without thought.
James
2025-01-02 17:54:38
I bought lots of these in bulk many years ago from a different supplier but recently ran out. I ordered these as replacements and they're exactly the same as the ones I used previously.Not a super interesting item but essential for placing IC's in DIY projects because you really don't want IC's to get hot and melt before you've even used them, plus you can always uninstall your IC's out of these sockets later and re-use them if you decide to upgrade your project board or just need the IC's for a new project at short notice.
Recommended Products
$12.50
$ 6 .99 $6.99