Your cart is empty.
Your cart is empty. Description:
Widely used in circuit boards, breadboards and all pcb projects, perfect as a toggle or on off switch for your projects.
Specification:
Product Name: DIP Switch
Type: Horizontal Type
Features: 8 Positions ( 2 Row 16 Pins)
Positions: 1/2/3/4/5/6/7/8
Pitch: 2.54 mm
Non-Switching Rating: 100mA DC 50V
Switching Rating: 25mA DC 24V
Contact resistance: 50mΩ 24VDC/100mA (at initial),100mΩ typical, 24VDC/100mA (after life test)
Each Size： 21.5x8 x8.5mm(L*W*H)
Main Material: Plastic, Metal
Package Content:
Package Content: 5 x DIP Switch
Richard B.
2025-06-26 14:52:59
These are way better than the big boxy ones that you usually see. I had some of those ones and the pins were short and the switches were stiff, so I kept popping them off the breadboard whenever I tried to do anything with them.These ones sink in nice and deep like an IC and the switches are easy to toggle. Definitely recommend these ones for breadboarding.
Jershon Eagar
2025-05-14 12:02:22
As advertised, work great
N & C
2025-05-04 12:38:58
Pretty good for dip switches! The switches themselves seem a little sticky, I have to yank pretty hard sometimes. I have torn up a few with a screw driver due to this but at least they fit in a breadboard just fine!
Davis Bourne
2025-03-13 15:33:16
Bought to replace a switch from Ben Eater’s 8-bit CPU kit which was too shallow to work well for breadboarding. These switches sit down like any other IC and are very solid. Highly recommend
Richard B.
2025-02-23 10:09:34
These are way better than the big boxy ones that you usually see. I had some of those ones and the pins were short and the switches were stiff, so I kept popping them off the breadboard whenever I tried to do anything with them.These ones sink in nice and deep like an IC and the switches are easy to toggle. Definitely recommend these ones for breadboarding.
Jershon Eagar
2025-01-10 16:29:14
As advertised, work great
N & C
2024-11-29 16:52:02
Pretty good for dip switches! The switches themselves seem a little sticky, I have to yank pretty hard sometimes. I have torn up a few with a screw driver due to this but at least they fit in a breadboard just fine!
Davis Bourne
2024-11-27 12:39:26
Bought to replace a switch from Ben Eater’s 8-bit CPU kit which was too shallow to work well for breadboarding. These switches sit down like any other IC and are very solid. Highly recommend
Recommended Products
