Your cart is empty.
Your cart is empty.Product Description
Find Various Sizes | Click the Links Below:
Application
- This collet is used for CNC milling lathe tools and engraving machines.
- The collet must be placed into the collet chuck nut before inserting it into the collet chuck.
- Used with straight shank, tool holder, extension bar nut; used to hold drill, boring tool, carving tool, and reaming tool.
Robert Michael Cargill
2025-08-27 11:38:19
Works
frank carcieri
2025-08-26 15:55:44
Needed for metric tool I purchased
Kent R.
2025-05-18 10:25:11
I needed this to adapt a electronic edge finder on my mill without removing and installing a r8 adaptor. Allows me to use the same size end mill.
James White
2025-05-07 10:51:21
The runout on it is not bad. The edges were polished to the point that they are slightly rounded off. The retension spring is unable to hold the collet in the cap. The collet gets stuck in the body of the chuck and has to be pried out.
Austin G.
2025-05-05 17:36:40
Collet fits too loose into the nut
eric buchanan
2025-03-24 11:52:36
Project wasn't bad but it needed instructions other than that was a good product would recommend
Brian W.
2025-02-13 13:47:04
Perfect just as ordered
PP
2025-01-30 13:00:06
Run-out at collet edge is over 0.005", and 2" away, it is 0.012". I was planning to use it to hold an electronic edge finder, but it is unusable for that purpose (or any purpose on a mill really). Looking at it a bit more closely, I note an 1/2"x ~100 degrees area of quite rough interior surface, about 1/4" from the edge. There's also an aborted slot cut on the back end.Sheesh!
Recommended Products
$22.45
$ 10 .99 $10.99
$13.19
$ 6 .99 $6.99
$12.67
$ 6 .99 $6.99