Your cart is empty.
Your cart is empty. Features:
Size: M12 x 1.5
Width Across Flats: 25mm / 1.0"
Thickness: 10mm / 0.39"
Material: Carbon Steel
Accuracy Grade: 6g
Package: 1 x Hex Rethreading Die
Description:
1. Made of heat treated carbon steel, high strength and hardness for a long tool life.
2. Hex die is for dressing over bruised or rusty threads.
3. No special holder is required for this type of die, any wrench large enough will suffice.
4. Their powerful construction helps ensure that bolts fit tightly and anchor securely.
5. Ideal for maintenance and repair work in the shop or field.
6. Die size is etched on the surface for easy identification. The first number represents the diameter of the machine screw die; the second number is the distance between the threads per inch.
Cskim
2025-09-04 15:26:45
Initially, the product did not work because I failure to use it properly. Then, I saw Youtbube to see how people using Dies. Then, I use the DIe to rethread the shot-up wheel studs on my 2016 Genesis G80, and I worked great. I save $$$ now i dont have to replace studs.
moni24862
2025-09-03 21:30:27
I used this to chase threads on an old bolt. I did not use it to cut new threads on bar stock, but for what I needed it worked very well. It got the threads alligned and repaired on the first try.
leo wink
2025-07-07 17:16:06
My threads were abysmal. These made them brand new again.
Vickie Sikes
2025-06-10 18:41:47
This product was the right size for a single bolt that had to be used on a set of 6 very special bolts supporting a freestanding bathtub. There was no replacement bolt that size available locally.
Altimatic
2025-04-23 10:33:38
The m12 x 1.5mm die piece worked very well to rethread a damaged stud
Phil Peter
2025-04-14 18:15:20
Worked great, restored my threads.
Mathis
2025-03-28 12:40:03
After many years of using an impact gun to put on and off my wheel, my studs were getting a bit stripped and it was getting a bit hard to put the nuts on my wheels at the point that I couldn't even tighten them by hand anymore. But after using this I can put my nuts on by hand no problem.
Brad. V.
2025-01-31 17:16:14
A standard die is difficult to use on wheel studs on that are installed in the hub because the handle won’t turn (it’s blocked by the other studs). This solves that problem by allowing you to use a socket.
Alain
2024-11-29 17:10:31
Travail bien fait travail
Marc
2024-11-13 15:19:01
Very happy with the result, great product!
Recommended Products
