Your cart is empty.
Your cart is empty.Product Description
Features
These Knurled Insert Nut can be widely used on the injection for tightly fixing.
Can be installed by ultrasonic or heat into the plastic matrix, or formed during the injection.
Due to the embossing process on the outer diameter of the insert, it forms certain friction and bites force with the brass insert after forming, which can be fixed on the inside so that it cannot fall off. Has a certain torsion and tension.
MidLifeHiker
2025-08-23 15:19:43
I use Uxcell brass inserts for all my 3d printed projects with more than one part. These inserts work very well and are easy to insert with a soldering. I do recommend getting a soldering iron brass adapter to use when inserting. These inserts take your 3D printed projects up another level. I know there are cheaper inserts, but these work so well, I'm not going to waste my time looking for an alternative.
Ryan S.
2025-08-22 21:06:58
Needed to make a new frame for my AnyCubic resin printer because they discontinued the product and the 3 party replacements are overpriced, or wrong size entirely. These are quality, no burs, clean threads and most importantly the correct size.
Matt Lee
2025-08-01 15:25:51
Great price with quick delivery.
Ken
2025-07-15 10:57:03
I nearly replaced the entire vat because resin had worked its way into the threads of the screws and hardened - making it impossible to remove the screws without an extractor. Needless to say some of the anchors had to be replaced afterward. I used a soldering iron to carefully heat the old anchors and then pried them out - then used the iron to push these in. These are seemingly an exact match for the anchors that were already installed in the tank, so they worked perfectly.
Phil Tuttle
2025-07-03 13:36:38
This was my first order of the threaded inserts and the quality is fantastic. Will likely need inserts in the future and will order again.
Benjamin Mergen
2025-06-18 16:37:10
Not sure how you could knock these in any way. Matches description 100%. If you've never worked with these, they're great. Very satisfying to install. If you have a problem with these, you're likely doing something wrong.
Joseph Machnak
2025-05-29 13:57:09
Perfect.
Wrong size
2025-05-02 10:58:28
they don't twist out or pull out, so long as you don't over tighten them you can pull on it with 100 lbs
Jim
2025-03-10 20:43:59
These work well as basin/sink anchors when epoxied into the underside of a counter top.
benoit
2025-03-01 17:00:15
Tiens solidement lorsque bien inserer dans le PLA ou le PETG et Autres
Valadas
2025-02-08 18:35:46
None of them was mishaped like some others I received. Good quality, precise threads.
Kim Campbell
2025-01-23 12:05:03
Not much to say about them, they're accurately threaded, and are exactly as described
Alan
2025-01-07 11:22:02
Work well. Would recommend.
Recommended Products