Your cart is empty.
Your cart is empty. Specification:
Model: SCE108
Drawn Cup Material: ST14 Steel
Cage Material: ST13 Steel
Needle Roller Material: Chromium Steel (GCr15)
Accuracy: P0
Bore Diameter (Fw): 5/8" / 15.875mm
Outside Diameter (D): 13/16" / 20.638mm
Width: 1/2" / 12.7mm
Dynamic Load Rating: 8100N
Static Load Rating: 12000N
Number of Pack: 5 Pcs
Description:
-Drawn Cup Needle Roller Bearing features a deep drawn, thin-walled outer ring. They are compact bearings with high load carrying capacity and stiffness.
-These bearings are especially suitable for high dynamic loads or radial-limited installation. They are mounted with a tight interference fit in the housing.
-Shoulders or snap rings are not required to locate the bearing axially, thus enables a simple and economic design of the housing bore.
-For various applications such as agricultural and construction equipment, pumps and compressors, and two-cycle engines, among others.
NOTE: Install with press machine or special tools instead of hammers because beating may lead to local deformation.
M. Hxxxxxx7
2025-09-01 12:55:58
I used 2 of these to replace the input shaft bearings on a Honda lawnmower transmission. Mower model HRC7113 walk behind. Spicer 4360-102 transmission. Works great.
Trevor
2025-08-31 10:10:04
Fits as expected, high quality, does what they’re advertised to do. Second time I’ve ordered them because I’m so happy with them.
CHARON
2025-08-17 11:24:11
As described and on time
Customer
2025-08-11 11:22:30
Size was good. They came heavily greased. Not sure if you have to re-grease them when dry. Used to replace the same sized bearing from McMaster-Carr. Don’t freely roll as well as my previous non-greased bearings. So, they are the right size and work fine. The grease just throws me off.
roger v.
2025-08-10 15:36:19
It the correct part and came in two days late
D. Engel
2025-08-07 13:50:03
Listed at .750 shaft size. Managed to get a .754 minus gage pin through it without a lot of effort.
M. Browning
2025-06-13 14:44:27
Used to place on top of a whirly-gig. Diameter was perfect and the top moves freely with the wind
B.O.B
2025-05-21 13:53:34
Used for wheel axle to help the axle spin more smoothly
Colin M.
2025-05-08 10:39:58
I like the bearings ,i use them in snowblower
Ken vanderkleyn
2025-03-21 16:13:35
Worked well
Ralph Tarnasky
2025-02-10 20:18:24
They seem good quality for the price and hopefully in a few months I can rate their service.
andy foster
2024-12-18 10:44:29
quick delivery and good fit
Recommended Products
