Your cart is empty.
Your cart is empty. Description:
Needle Roller Thrust Bearings provide a high degree of stiffness within a minimum axial space. It has a smaller cross-section than a standard thrust bearing for use in restricted spaces.
These bearings to accommodate heavy axial loads and peak loads due to small diameter deviation of the rollers within one assembly.
Made of hardened spring steel, both faces of the washers are polished and can be used as raceways.
Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics, elevators, rolling mills, ship rudder shafts, and aggregate crushers, among others.
Specification:
Bearing Model: TC1625
Bearing Washer Model: TRA1625
Needle Roller Material: Chromium Steel (GCr15)
Cage Material: ST13 Steel
Bearing Washer Material: 65Mn Spring Steel
Bore Diameter: 1"
Outside Diameter: 1-9/16"
Bearing Thickness: 5/64"
Washer Thickness: 1/32" (Approx.)
Package Contents:
10 x Bearings
20 x Bearing Washers
Another Old Guy
2025-08-04 11:39:22
Work as intended, and the price is good… thank you seller!
Wrist Roller
2025-06-16 10:33:10
Bearings are awesome!!
Lindsey
2025-03-29 09:10:44
time will tell but for right now these are working well on a 1995 white 42 rider mower. The price was the best and I will probably purchase again.. NOTE I had another mower that I could not use this set up on because of the length of the kingpin being too short so make sure you have the thickness available also there are 5/8 and 3/4 diameters pregrease on install incase your grease fittings do something stupid like allowing grease to go into the axel tube itself. juzzzz sayyynnn
WPR Inc
2025-03-22 10:08:44
I purchased these to put on wheels onto a floor jacket to make it easier to move. My floor jack is old and weights about 90lbs. I wanted to make sure the wheels turn freely from any side pressure when carrying a load.
Customer
2025-02-28 16:58:50
Excact fit
Cabinetm8r
2025-01-07 20:59:10
I was pleased with the quality, but the metal is quite brittle. Make sure your surfaces are parallel and smooth. I snapped a couple because one surface was not parallel. I do recommend these.
DAN J. DEPEW
2024-11-29 10:47:45
Fit perfect
Recommended Products
