Your cart is empty.
Your cart is empty.JustReviewin'
2025-09-02 14:37:38
I've purchased Vevor brand before for tools, and they make good products. This dip station / parallel bar is most likely the same quality or better as the more expensive ones. I'm 190 lbs, and it's very sturdy for me, excited to start using it. Just getting into dips, I ordered a an exercise band to go with it to make them easier. The hardware is great quality - bolts heavy duty, powder coated flat black square tubing, good looking welds. The only con is that I would have liked to see welds on all four sides of the top post, but it feels strong with only two. One of the screws would not go in all the way, but the rest of it was perfect. Good value, especially since it's so heavy and shipping is included with the price. The instructions are a bit small and hard to read, so it helps to look at their photos to put it together. You'll need a ratchet, wrench and a hex key tool. It does not come with any tools.
Quinkin
2025-08-18 13:19:17
I was actually impressed that everything mostly went together as intended. This was a fairly complicated piece of exercise equipment to assemble and took quite a bit of effort. Good thing I have a good tool set because no tools were included. Also, the "instructions" are a joke. I've seen BBQ assembly instructions that are better. The worse part was near the end. I had the whole base assembled (finally) and just had to attach the handles. Unfortunately this requires special brackets that were not in the box. What a pain. Using brackets like this is a really poor design. They should have just fit right over the uprights and been held in place with a big pin of some sort. The big A wanted to replace the whole machine which is a non starter for this decrepit old guy because is weighs about 100LB and is fairly difficult to assemble, disassemble, pack and then ship. The good news is that I was able to find the manufacturer's website and drill down to someone in customer service via chat who told me they would send me the brackets. Let's see how that goes. I'll try to update this when it happens and if everything goes smoothly I may add a couple stars. [UPDATE] the missing parts finally arrived shipped from China via FedEx. It is now about 3 weeks after the equipment first arrived. I am actually amazed they have someone there who was able to get this done so I added a couple of stars. Thank you Vevor Customer Service Rep. I really appreciate your effort! Well done.
Ash Afshar
2025-07-30 21:36:50
but too wide for proper dips, so that sucks
Placeholder
2025-06-23 17:39:58
Precision manufactured and extremely well built. Very reasonably priced and suitable substitute as parallel bars for PT rehab and balance exercises. Can easily use plywood to build a flat base over the lower frame. Poor assembly instructions if your not handy.
Susan A.
2025-06-16 11:54:56
While the unit is very stable and easy to assemble, to properly perform dips or any parallel bar exercise your hands should be directly under your shoulders providing proper alignment of the joints. These bars are 25†apart. For 95% of humans this places hands out away from their body flaring the elbows and putting too much pressure on the shoulder.
MiamiNice
2025-06-14 21:11:59
Just did the assembly yesterday, it took me less than two hours. Instructions are terse, but accurateSuggestion to seller: pack screws in different labeled bagsAlso: the count of screws is perfect, I used them all, but to have a couple washers extra would be nice, in case you loose one during setupVery happy with the unit
Ramon G.
2025-06-12 16:27:15
The media could not be loaded.
timex
2025-05-22 15:22:04
Mit zwei Platten aus dem Baumarkt habe ich aus dem Gerät einen kleinen Barren gebaut. Der originale Abstand der Stangen beträgt über 60 cm. Ich habe einfach neue Löcher gebohrt, um auf eine Breite von 50 cm zu kommen. Den Überstand der Querträger konnte mit einer Eisensäge leicht abgesägt werden. Das ganze ging nur, da die seitlichen Stützen geschraubt sind (siehe Bild). Ohne die seitlichen Platten (120x36 cm) hat das Schwingen nicht funktioniert, da sich das ganze zu stark verwindet. Die obere Schraube ist 10 cm von der Höhenverstellung gebohrt, da der Lochabstand 5cm beträgt. Dadurch kann ich die Stange mit etwas Aufwand immer noch flexibel in der Höhe einstellen. Der obere Holm ist sehr solide und eignet sich prima zum Schwingen. Da er nicht federt sicher nicht für alle Übungen.
Shawn
2025-05-21 10:10:19
It works great for my son to learn to walk again. At 19 he lost the the ability to walk and he's 21 and home but wants to walk and this gives him the chance.More weight or a way to attach to floor for more stability...
Olivier S.
2025-02-10 19:39:32
Ein paar Mal benutzt, tut was es soll. Unten bei der Abstands-Stange ist eine Schweißnaht gerissen, aber alles hält trotzdem. Im Notfall kann ich sie durch einen Holz-Balken ersetzen
Kunde
2025-01-15 17:51:32
Für den Preis super. Aufbau und vor allem sortieren aller Teile war aufwändig, gepasst hat aber alles.
Recommended Products