Your cart is empty.
Your cart is empty.Product Description
Waterproof Inline Cord Switch AC 110-250V 2 Outlet
- Material: Plastic，Alloy, copper, iron
- Working Voltage：110V-250V
- Working Current: 16A-20A
- Switching Mode: ON-OFF
- Line Port: 2 Outlet
- Termianl: 4 Pin
- Light Color: red
- Waterproof Rating: IP66
- Installation: Screw
Package Contents
- 1×Red light rocker switch
- 1×housing
- 1×Waterproof rubber ring
- 4×screw
- 2×PG11 Waterproof Connectors
housing
High quality plastic injection molded in one go, with good toughness, no cracking or deformation,
1.Even at minus 40 degrees Celsius, it will not crack or deform.
2. Strong flame retardant ability to ensure safety.
3. Compact design for easy installation
ON/OFF switch
High quality waterproof switch
1. Silver contact
2. Waterproof (IP66)
3. Long service life (can be reused 100000 times)
PG11 waterproof Connector
1. PG11 is suitable for cable diameters ranging from 5mm to 10mm
2. PG11 can be installed and disassembled according to your needs
waterproof rubber ring
The waterproof rubber ring produced by a one-to-one mold
1. Better waterproof ability
2. Not easily deformed
3. Not easily aged
Kevin Wallis
2025-09-04 13:55:04
Item as described. Works great!
KWIKBIT
2025-08-25 15:02:14
Well made, good material, good lid seal! If you use waterproof cable clamps you should have no water/moisture issues.
Jerry Brown
2025-07-28 17:24:49
Seems to be doing what it's suppose to
larry knutson
2025-06-14 18:59:28
Easy to use.
James A
2025-06-10 17:22:34
I'm using this device to house a weatherstation controller I built. Overall, it is fine. A few notes:* It would be nice to have a detailed drawing of the mounting points in the backplate. It seems like you can screw into them with m3 screws and it holds decently well. However, with detailed drawings it would be easier to design mounting structure for electronics inside the box.* The screws are already showing surface rust after only a few weeks outside. None of the other stainless hardware on the weather station is showing any rust at all, which to me indicates that these screws are not stainless.* The grommets are REALLY tight. You will not be able to pass any cables with installed connectors through the grommets. I had to cut all my cables, then pass them through, then crimp/solder/attach new connectors on the other side.Other than that fine I guess. This box ended up causing a lot of work and I would probably try to find something different next time.
Funny books ( L)
2025-06-08 11:51:17
I used this on the roof of my motorhome to run wires from the solar panels to inside the RV. It's a bit smaller than I expected and you have to drill your own holes for the provided water tight fastenings. This slows you to just use the number of fastenings you need and put them where they work best. The lid has a thin soft rubber seal that is a little fussy but seems to work well. I really like the sturdy tabs that stick out on each end for fastening the box down. Each one has holes for two screws, so the four screws in the two tabs are very secure.
Motorguy
2025-05-02 14:33:53
Fits on a rubber covered cord. Installed easily and had lots of room for slack wires. Glands tightened easily on cord.
Mark V.
2025-03-04 13:09:04
Easy to install the case is large enough to work with.Great product !
mervin mckay
2025-02-20 10:27:12
fast delivery
Recommended Products