Your cart is empty.
Your cart is empty.Product Description
Momentary Rocker Switch
weideer Jack Momentary Switch Reverse Polarity Toggle Rocker Switch DC Motor Control RV Power DPDT 4 Pin(ON)-Off-(ON) 20A 12V DC with Wires for 5th Wheel Tongue Trailer KCD2-7-223-4P-X
- Pin Quantity:4 Pin
- Contact Type:DPDT
- Size：45x20x45mm / 1.75''x0.76''x1.77''（L * W * H）
- This switch is momentary Automatic Reset action
- The switch comes with a jumper, easy to install
- jumper wires length: 21.2cm/8.3''
Product package
1pcs rocker switch+4 Connect wires.
RareAir
2025-09-04 15:46:31
I recently replaced the stock button on my Rpod 202 trailer jack switch with the Weideer 12V Reverse Polarity Switch, and it has been a great upgrade. The stock button had started to fail, especially when raising the jack. The Weideer switch fixed this issue perfectly.Installation was straightforward and the switch fit seamlessly. The quality of the Weideer switch appears to be superior to the original, feeling more robust and durable. Only time will tell how well it holds up, but so far, it’s performing better than the stock button.
fgs
2025-09-03 11:18:42
My original switch wires were soldered to the terminals. That original wire is at least 12gauge in thickness. That makes sense, as the trailer jack draws A LOT of amps. (The inline fuse is 30A, which blows immediately when the jack hits the max extension!) That said, I was surprised at how small (probably16 gauge) the included wire pigtails were. I didn't think a regular crimp would be adequate for splicing the wires, so I soldered the wires first and covered the splice with a heat shrink fitting (Solder seal wire connector) The switch fit perfectly, and works great. I hope the pigtails are adequate for the amperage load. I'll open up the trailer jack panel and check down the road.Footnote: Several people commented, in their reviews, that the switch works backwards. This switch will REVERSE POLARITY. One direction makes the jack go UP, and the other direction makes it go DOWN. If they are backwards in relation to their labels, switch the wires that go to your motor! ...basic electricity.
Glenn Goetzinger
2025-07-02 10:52:37
Worked great as a replacement on my lippert tongue jack. My lippert switch failed in 8 months, manufacture warranty is garbage. They wanted to sell me new switch for $46.00, this swith fit perfectly, took me 7 minutes to replace. At a fraction the price. Highly recommend!!!!
Stephanie H.
2025-06-29 13:27:31
This 4-pin replacement switch was exactly what we needed for our RV jack that had been acting up. It fit perfectly and worked like a charm. The installation was a breeze—took less than 10 minutes, even for someone with minimal experience. Our RV jack is back to functioning smoothly, and we couldn’t be happier with the results. Highly recommend this switch for anyone dealing with similar issues!
Brent Rayfield
2025-06-26 17:52:47
Part works as expected. No issues after 3yr of use.
Review
2025-06-20 11:04:02
Works great and easy to hook up
Ryan
2025-05-19 14:58:48
This was a perfect replacement switch for a 6 blade RAM power tongue jack as far as functionality. Much cheaper than spending $30 for a simple switch. The only thing you will have to modify is bezel out the opening in the cover for the OEM switch a little and this will fit fine...seal up with a little silicone and you're good to go.
Darrell E Dennis
2025-04-17 15:06:54
easy to install, works good on the camper jack
Customer
2025-04-03 10:24:17
The switch arrived quickly and was a described. My husband was able to install it, using the existing (factory) wiring on our tongue jack in about 10 minutes. Note for those with little to no electrical knowledge, this switch did not come with any instructions.
Kristopher
2025-03-23 11:02:38
These switches are far higher quality than the Briggs and Stratton switches that came on the snowblower. I have gone through numerous of the factory switches that are over $100 each!! and after reading online I’m not the only one whose had this problem. The plus side is these bad boys fit perfectly on my snowblower all I had to do was bend the outside contacts slightly and the plastic will chip away a bit but they fit super snug and work like a charm! You can feel the quality difference in the switching they just rock so much nicer than the Oem ones.Briggs and Stratton should be charged criminally for charging over $100 for switches that don’t last one damn season (not even one of them made it a whole season out of 4!!!) and when you’re in the middle of trying to clear a 100’ plus long driveway and the chute stops working and you’re stuck in one position the level of frustration i felt damn near took the whole snowblower to the dump!
Mahon Clan
2025-03-07 12:33:58
We were told we would need to replace our whole RV power jack. This saved us from having to do that.
rod Gathercole
2025-02-05 16:12:00
Replaced on electric jack works great.price reasonable.
MACMAN
2025-01-18 21:40:29
Amounting trim would be nice
Recommended Products