Your cart is empty.
Your cart is empty.Product Description
- Vehicle Fitment:
- Compatible with Buick:
- Rendezvous 3.5L 2006-2007
- Terraza 3.5L / 3.9L 2005-2007
- Rainier 4.2L 2005-2006
- Compatible with GMC GM:
- Sonoma 2.2L 1998-2003
- Canyon 2.8L / 3.5L /2004-2006
- Envoy 4.2L 2002-2007
- Compatible with Pontiac:
- Grand AM 2.2L 2002-2005
- Sunpire 2.2L 1998-2005
- G5 / G6 2.4L / 3.5L / 3.9L 2005-2007
- Firebird 5.7L 1998-2002
- Compatible with Saturn:
- Vue 2.2L 2002-2007
- Relay 3.5L / 3.9L 2005-2007
Colt
2025-08-28 12:35:59
Worked. Reasonably priced.
Kindle Customer
2025-08-10 14:23:05
His map sensor was the right one it fits and it works what else can I say
Joseph
2025-07-31 15:30:37
Sensor definitely has the car running better. Only time will tell how long it’ll last but the price was right. Will re-review after a while.
C. Countess
2025-05-25 16:24:16
After trying for weeks to get a clear indication of what was causing my Colorado to run like crud, finally the code indicated a bad MAP sensor. Locally, that sensor was priced around 75$ and up. Since I had access to an identical truck, I thought about waiting a few days until we could swap the sensors out truck -to-truck and be sure before spending that money, because, sometimes, the codes are wrong.Then, I found this on Amazon for under 13$ And next day delivery! I'll took a chance on the 13$ sensor. Ordered Friday, had it in my hand Saturday. Visually identical to the old sensor right down to the injection molding marks. Installed it, runs perfect.It has been a few weeks, still no problems. At this price, maybe I should even buy a spare?
J. Campbell
2025-05-20 12:01:11
2005 Saturn Vue, 2.2L, 4cyl...... Part fits exactly as stated. You must remove the throttle body (requires a 10mm socket - use a 1/4 inch drive with short extension for best results). Clean the throttle body with throttle body cleaner (similar to carb cleaner) while you have it off; HOWEVER, take care because there is a gaping hole into the block when the throttle body is removed so don't accidentally drop something in there. I covered it with a clean rag.Old part will pop right out.... turn the MAP sensor toward you (out away from the head) and pull up (may have to use a flat head screw driver to lightly pry it up from the block). The part will pop right out. Put the new part in (basically, reverse the order) .... once in, reconnect the wire harness to the MAP sensor, make sure everything is in place, carefully place the throttle body back in place (there is an O-ring gasket that seals it so take care not to over tighten or scuff the O-ring), tighten the 4 screws (hand tight with a light touch extra), replace the air vent hood - make sure the air temp sensor is harnessed up ..... You should be good to go.I was very concerned with this DIY project - I am not a mechanic - but, if you are fairly good with a wrench, you should not have a problem. Both the part and the Seller were on target.
MALCOLM J.
2025-04-10 11:13:57
No good at all i had to buy more expensive brand now light does not come on
Micheal J Fontenot
2025-01-30 14:57:11
Fast delivery, Exact item, Will do business again...
Sherri
2025-01-21 11:48:34
easy to put on car
Recommended Products
$29.55
$ 12 .99 $12.99