Your cart is empty.
Your cart is empty.Zero start 3100025 Freeze Plug Engine Block Heater for Kubota, 35mm Diameter , CSA Approved , 120 Volts , 400 Watts. Kubota D102, D1302, D1403, D1703, D1803, D2203, D2403 (3 cyl. ), S2800 (6 cyl. ), F2803 (5 cyl. ), V1702, V1703, V1902, V1903, V2003, V2003T, V2203 (4 cyl. )
Tiny
2025-08-15 17:18:57
Put on a 4 cyl kubota that is 100% exposed to the elements on a sweeper truck. 20 degrees out and it starts right up....Just buy it
Heather
2025-07-27 18:11:05
Had a V1903 put in the 2 clock position plugged in come back check on it and nothing checked with ohm meter it's a open circuit checked cord all okay on cord why element burnt up? Loosened plug it leaks antifreeze and I did run engine before plugging in
Jacob B.
2025-07-13 12:26:43
Fit a bobcat 773 just fine, it didn't tighten up as tight as I'd expect but it didn't leak was pretty easy to install
A
2025-07-04 16:29:13
Perfect fit and works as expected.
Lounar
2025-06-24 12:27:54
Company was very good in confirming the proper model and even telling me where to install this as I thought it went into the block but actually goes into the head. It has been in 2 mos now and not leaked a drop.
Sequoia
2025-06-18 11:06:56
The production looks fine but doesn't fit my equipment even if it was listed in the description. The most important is i'm not able to return...
tnwenger4450
2025-06-10 10:53:11
Had to get a different o ring to seal the heater in a Bobcat S175 with a Kabota V2203 engine.
Marc
2025-02-02 13:45:54
This won’t fit unless you want to pull your engine to install it. The proper heater needs to be a kabota heater with a sleeve to keep the heater away from the block. Trust what I tell you!!!!!!! I ordered it and I’m sitting here -30 in Minnesota with a skid loader with no coolant in it and no where to get the proper heater. Can you say fun?
Gil Rand
2024-12-06 10:26:14
The block heater is fine and I'm sure it would work as expected. Unfortunately I bought this for a 742B Bobcat Skid steer loader with a V1702 Kubota engine and found out later that because of the position of the engine it would be difficult if not impossible to install. Evidently there is a metal plate between the engine and pump that prohibits installation in the rear of the engine head. I did not bother to return this item as I will likely be able to use it elsewhere if i can find it when I need it. There is a frost plug block heater, for the side of the head, available from Bobcat that will work and does not involve engine removal or modifications.
Recommended Products
