Shopping Cart

Your cart is empty.

Your cart is empty.

Zerostart 3100045 Freeze Plug Engine Block Heater for Caterpillar, Detroit, Massey Ferguson, Perkins, 1-1/2-Inch Diameter | CSA Approved | 120 Volts | 600 Watts

Free shipping on orders over $29.99

$45.00

$ 19 .99 $19.99

In Stock
  • Ensure quick winter starts and reduce engine wear
  • For Caterpillar, Detroit, Massey Ferguson, Perkins. See Zerostart catalog for specific applications.
  • 1-1/2-Inch diameter
  • 5' (1.52m) cord included
  • Volts: 120 | Watts: 600 | Plug Type: 120 Volt, 15 Amp (Type A)
  • CSA approved


Zerostart 3100045 Freeze Plug Engine Block Heater for Caterpillar, Detroit, Massey Ferguson, Perkins, 1-1/2-Inch Diameter | CSA Approved | 120 Volts | 600 Watts. Catepillar 3054, 3056, Perkins 400 Series, 1004, Detroit Diesel Series 30, Massey Ferguson MF-3120, MF-3140, 1006.


Customer
2025-08-24 14:46:03
Fits like a glove and a very good price
Stephen J. Krueger
2025-08-07 13:35:14
Listed for Ford/New Holland 1910 tractor. As shipped it will not fit! Unit to small for the freeze plug hole, needs new/thicker "O" ring. Replacing the O ring seals the freeze plug hole but not sure if this is a temporary or permanent fix. The item is also larger than the OEM heater and very difficult to install/orient, I think because of it's length.
E J
2025-05-29 10:11:40
purchased two of these for standby generator. installed both one active use other for backup. One month of use first one is tripping ground fault, this a problem that will only get worse. now using backup, hopefully will last long enough to get replacements. Not what I what i was expecting.CAN NOT RECOMMEND
Wells Turnage
2025-03-27 12:58:15
supplied O ring gasket did not large enough to seal. After some experimenting installed a thicker O ring and it worked (after leaking antifreeze and making a big mess).
Kh
2025-01-24 18:28:34
Did not come with block heater. Plug in only
Robby
2024-11-14 14:05:07
The block heater was correct but had been previously usedPackage was re taped closed and the dirty finger marks were all over the instructions and package. The o ring of the heater was damaged. I had to replace it with one I had.I had to use it anyway because I needed to complete my work.