Your cart is empty.
Your cart is empty.LOSTRONAUT's setup bars will not damage carbide saws and router bits as they are made of solid brass. Features include: Marking is a breeze! Easy for you to set fence and cutter heights Sizes on each bar are marked with laser engraving for accurate quick work and easy measurements All 2-1/5 inches long this set comes in 10 sizes: 1/8”, 3/16”,1/4”, 5/16”, 3/8”, 7/16”, 3/4”, 11/16”, 5/8”, 1/2” square Stack setup bars for a wide variation or sizes or use on their own Includes a plastic storage case for easy access and protection Satisfaction guaranteed or no questions asked 30-day return for a risk-free purchase ✔ Order yours now! ✔
Sean
2025-02-09 12:55:28
Wanted some quality setup blocks for woodworking and these are good. They are nice and solid with tolerances averaging .001" when measured by my most accurate dial calipers; so very happy with that. Machining on edges and radiused corners are good enough. My only big complaint is the storage case, specifically, the foam cut-outs they sit in. The blocks are too close together ,the foam too dense to give, and the cut-outs too deep to get your fingers around the smaller ones to easily pull out (and I don't have sausage fingers). Fixing any 1 of these would resolve the issue. At first it was a minor nuisance but the more I use them the more annoyed I get. Especially since it seems like I'm always trying to get one out with one hand. In fact, my annoyance was almost to the point that I was going to return them, but their accuracy is more important to me than the aggravation the foam causes. I'll probably just end up putting some sort of spacer underneath the smaller blocks so they don't sink into the foam when your trying to get one out. I paid $50 for the set and I think that's a decent value. All in all, definitely a solid set of bars that I rate at 4.5 stars. Now just make a set in metric.
Recommended Products
