Your cart is empty.
Your cart is empty. Maximum Angle :360 degrees
Operating Voltage : 4.8V
Operating Speed : 0.11 seconds / 60 degrees
Temperature Range : 0 ℃ -- 55 ℃
The dead-band setting : 5 microseconds
Line Length : 300MM
Plug Type : JR, FUTABA general
The factory setting of the valve is 90 degrees, the pulse signal value is 1500, 500-2500 signal range, and then rotate from 90 degrees, if you need to adjust according to the signal range of its pulse setting
Servo working principle: the signal is aborted, the servo stops, and then the signal is output to the servo again at zero degree, and then start the second round of 360 degrees
Package includes:
12 x MG90S 360 degrees micro servo
12 x Servo arms and screws set
Mbunds
2025-08-13 14:20:31
These are typical, no better or worse than others. All 12 that were shipped work perfectly.I do like that the plastic gears will tolerate a bit of "grinding" if the load is too heavy, but otherwise these are typical but very good for the price.
Omar Khan
2025-07-27 15:06:35
Although many people are saying there are some plastic gears in there, the main one is metal.It has worked well for my RC plane projects, and have taken a beating, but still work just fine.
Lonnie
2025-05-08 17:52:26
Used these in a ground based (thankfully) project. 12 servos. 4 plugged into the board overloaded the 3 amp buck converter at an idle. Found some the pulled too many amps. A few completely dead. Some get hot. All are extremely weak. Your milage may vary, but there is no way i would purchase these again for any purpose let alone in a flight application. Of the 12, 5 are still in project. They are getting cycled out as i write this. Consider Miuzei instead. So far they are working smoother. On teardown they are not even MG90 servos. All gears are plastic but the one you see on the outside.
Matthew K. Wimmer
2025-03-26 10:19:29
These are not great quality servos. From my experience they have about a 5-10% DOA rate, and they also do not last as long as higher quality servos, even if they are not DOA. However, they are cheap as heck. If you need a bunch of cheap servos to do the job of cheap servos, this is a fine deal. $1.58/servo is throw-away money, but these are throw-away servos, you get what you pay for. If you want high-quality, precision servos for critical applications or use in twitchy or valuable flying models, look elsewhere.
David
2025-02-20 11:10:10
Good little servo for the price
Martin Rogan
2025-02-17 13:29:24
Cannot go wrong with metal gears. Use these in my foamie airplanes. Good price.
Brakemanbob
2025-01-18 12:56:54
I used the servos to control model railroad turnouts and so far they are working well. They came nicely packaged in and secure box. I tested all of them and they all worked and are working well on my model railroad. Good product, good price and they arrived on time.
WamperSnapper
2025-01-01 17:15:05
The media could not be loaded.
Viatcheslav Nasonov
2024-12-12 19:57:57
Works as expected.
Received no problem
2024-12-11 18:59:30
Working well
Recommended Products
