Your cart is empty.
Your cart is empty.*Specification: Working voltage: 0-36V Maximum pin current: 5A Interface type: 2pin Led light strip PCB width: 5mm Working environment temperature: -20~50℃ *Attention: 1. Please make sure that the contact point of the light strip is in contact with the copper sheet of the buckle. 2. When connecting the light strip, there is no need to peel off the adhesive on the back of the light strip. *Package including: 5mm connectors and 22AMG Extension Wires
Alterego667
2025-09-01 17:07:13
The media could not be loaded.
mels
2025-07-17 15:51:33
Sticks well to the camper shell. Nice light and color. Didn’t test duration but worked great so far. Not sure how different this “water proof†is compared to the normal one and if it is worth the upcharge. Next time for this application I’m going with the normal one
Rick
2025-07-11 17:29:34
This is a great product. Just to inform users, you can cut the strip anywhere as long as you cut it on the copper strips as mentioned by the seller. Also know that you can make any length of strip lighting including one small strip by carefully soldering feed wires to those same copper tabs.
DJ Speed
2025-07-01 15:51:56
For starters let's start with the product itself. It is bright. LEDs are really close together. You can't see each individual led.Very thin. I knew it was thin. But not that thin. The thickness of about 2-3 pennies is how wide it isBad. Very bad. I waited too long to check and now can't return it. I needed the full length of the spool I ordered. And about maybe 12in into the roll it was cut. I had 2 pieces. And the long piece that was still on the spool had the power wires cut on the other end. So now I only had 12in of usable wire. And the rest was useless
J in PA
2025-06-21 16:18:10
Had to return twice because the backing tape pulled all the adhesive off. Most likely stored or transported somewhere hot. Once I got a good set everything worked out. Lights themselves where bright and looked good
R.Daniel
2025-06-08 11:10:53
I built this custom task light for over my sink. I used the thin led strip to provide accent light over the main ‘shade’ part of the light. Came out nice and fit in that small gap just right.
JWO
2025-05-24 17:04:17
We replaced the ugly bright blue LED lights that came with our trailer and put this up instead. It made such a big difference! Installation was a breeze. We loved that we could cut and install from both ends so we used the majority to frame our pop out and the remaining portion was able to be wired in beneath our cabinets. It's bright but warm lighting. We love it!
t walski
2025-05-20 11:34:32
Used this in a wooden light fixture for hanging in my dinning room, the dimmer works great for mood lighting, and bright enough to read by even with it off to the side.
Armando GarcÃa
2025-04-19 10:35:33
Buen producto, ahora limitan existencias y han incrementado el precio en un 45%
John Taylor
2025-04-12 16:20:54
Bought to act as an uplight for a glass plaque in a metal stand. Worked really well. Very bright so I will need to add a dimmer. I cut this down to about a 60cm length. I went for it because of its width. Does not come with a power supply. I dug out an old power back from some long dead device (never throw anything out) and it worked fine
Ismael lopez pajares
2025-03-31 15:04:59
lo que buscaba
Rolhardy
2025-02-03 12:40:09
Très lumineux et peut se couper à mesure.Il y a moyen de résoudre des fils électriques pour faire d’autre rubans donc aucune pertes.Très bon achat
Super lumineux pour un si petit ruban
2024-11-26 13:21:32
Customisation d'un baffle de guitare pour qu'il soit en phase avec l'ampli qui lui aussi est éclairé de bleu.
Recommended Products
