Your cart is empty.
Your cart is empty. High quality brass collets to fit Dremel, other rotary tools, pin vises Compatible with most rotary tools used in hardware, hobby, home etc.
Product Description:
Specifications: Clamping Diameter :1mm/1.6mm/2.3mm/3.2mm(0.04",0.06",0.091",0.126")
Shank Dia :4.3mm/4.3mm/4.3mm/4.3mm(0.17",0.17",0.17",0.17")
Overall Length :17mm/0.67"
Material :Brass
Color :Golden
Measurement error Rang: 0.05mm
Included in the Package: 2sets 8pcs Brass Collet (size including 1mm/1.6mm/2.3mm/3.2mm and 2pcs one size)
karan val borda
2025-08-20 10:33:06
They work and fit well.
Mary Houston
2025-06-22 11:24:10
As a machinist /Toolmaker for over 30 years , I recognize quality tools! Dremel tools DO NOT disappoint!!!
Icabod
2025-06-13 15:09:26
We do lots of power carving. This requires bits of different diameters. The collets that come with most power units are have only a few standard sizes. I had some dental bits that just were too small for the collets. This set solves the problem.
NanaMaestra
2025-05-18 15:48:23
Idk if it’s the collette or the rotary tool itself—- I have several third party burrs that I’ve used for several years. They used to fit just fine, but my last craft attempts haven’t gone well because the shanks don’t fit well into the rotary tool. I use the largest collette, and the shank doesn’t go in a deep as it used to.
DBCooper
2025-03-31 14:24:35
Beginning when I was a pre-teen (1950s)my father, older brother and I were al very much into HO scale mmodel railroading. We shared a Dremel Moto-Tool. After I moved out I was an inconvenient distance from the old homestead, so I got my own basic kit. This was probably in the early 70s. It served me well, but over time I found that there are a lot of 3rd-party drills, burrs, rasps, diamond tipped saws, fiberglass disks, stones, buffing pads etc., with different shaft diameters or mandrels. The original basic collet is no longer sufficient. With this I'm in fine shape.
Tina
2025-03-07 16:37:50
Decent value
Bill
2025-03-01 11:40:15
Exactly what I needed
Audio music engineer
2025-02-09 13:05:51
If you have shafts of different diameters, you will need this with an extra set of 4 different sizes
Recommended Products
