Your cart is empty.
Your cart is empty.Drdrdaddeo
2025-08-26 17:15:46
Very affordable 2hp pool circulating pump. Arrived well-packaged ahead of schedule, with all accessories and a user manual. 220 V electrical hookup was simple with clear directions provided. My suggestions on including a wiring diagram of the 120-240 volt switch were sent to seller, as I initially had electrical hookup questions which seller promptly responded with a picture and perfect guidance. This motor is very quiet and seems much more more powerful than my old 1hp Hayward pump, which died after 8 years. The inluded 1 1/2†plumbing adapters fit my American PVC pipes perfectly. In fact the seller happily provided me 2 extra 1 1/2 “ adapters for free on request. This Chinese pump seems high quality, does not leak, is very quiet, and seems quite powerful at 1/2 to 1/4th the price of a high end American circulation pump. An excellent deal.Addendum: While this powerful pump worked perfectly in circulation mode, in vacuum mode its strong vacuum caused water trap cavitation and priming loss when used with my underground pool’s small (1 1/2â€) diameter plumbing system. This was not due to any leakage or fault in the pump. The supplier kindly (and immediately) helped me diagnose this problem and then resolve it completely by accepting prompt return of my SINGLE speed, dual VOLTAGE model, with replacement by their identical, dual SPEED model. The dual speed replacement pump can be used in vacuum mode at the slower speed with no loss of priming.Overall, this a superb, powerful pump, and its suppliers were invaluable with their immediate and kind support and assistance. .
Stevenator
2025-08-01 12:48:55
I bought this pump for a temp replacement while I rebuild my Pentair 2 speed pump. I hooked up this 2 speed 2.5 hp yesterday and it powers my waterfall and solar heater at same time on high and low speed. I used aftermarket 2 inch unions and lubricated o rings, used heavy Teflon tape on threads staying away 1/4 inch from o rings. I used insulated flag female terminal connectors (wiring diagram in box), cover screws hard to put back so use 1/4" nut driver. Switch on pump will pop out if not carefully but works good when seated. Fill pump basket and suction line with water and be sure to ground lug on pump with #10 or larger copper separately from wiring ground. Also be sure to check motor/wet pump bolts to be sure they are tight but don't over tighten. This pump started to prime on low speed but switched to hi speed and everything started flowing great. If this pump last 3 or 4 years it will be well worth the reasonable cost and I might just buy another backup and save money not rebuilding the Pentair pump. Time will tell just go over everything on pump, take your time and give a quarter turn on unions and bolts when finished.
Elizibeth Reynolds
2025-07-15 17:54:25
This definitely did the trick and was not to hard to put together yourself it has great suction power, works great. I have nothing bad to say and neither does anyone that comes to my house pool working great.
Jamie Talley
2025-06-19 16:34:32
The media could not be loaded.
Davy Jones
2025-01-09 14:19:33
This is a 2 speed motor which I wanted, however, even on high speed it isn't enough to run my pool sweeper! I was initially impressed with how quiet it was, until I found that is because it doesn't flow enough water to run sweep! Save your money and buy a higher flow rate/horsepower unit. FYI I don't have a large pool either, only 12000 gal.update: I explained above situation to the seller, and they were very good about stating that they would accept it for return with full refund, so no complaints there!
Recommended Products