Your cart is empty.
Your cart is empty.Product Description
Product Comparison
Faster and More Stable Motor
FT5330M 35kg servo motor small size, lightweight, big torque, high speed and less noise
RC servo, widely used in toys, remote control racing cars, airplanes, boats, micro robots, compatible with Arduino, Raspberry Pi
The steering gear suitable for 1/8, 1/10 scale tracked vehicles, tanks, off-road vehicles, remote control robots and boats
This digital servo has fast heat dissipation, high sensitivity, long life, and a cost-effective product
Wide Range of Applications
Suitable For Tracked Vehicles
Suitable For Airplane
Suitable For Mini Helicopter
ViDiViCi
September 5, 2025
The media could not be loaded.
Dan Homeyer
August 23, 2025
35g-20g THE BEST for your budget builds, The only difference between the higher dollar comparable ones is a little gear noise but these are plenty strong and long lasting. I have six 3- 35s and 3 -20s for over 2years, Zero problems never even get warm even when 95 outside......ALWAYS make sure of your end point adjustments and your servos will last. The 20s are perfect for Digs+Overdrives. OH, And do not put any servo to the WDW torture test. Nothing can handle that punishment for long....
Orion W.
August 19, 2025
It seems a bit weak for what task I put it up to. Which was replacing the old non hobby grade servo in my RadioShack Tremor, with a hobby grade one. Which worked. Sadly I had to trim the tabs off :'( BUT IT WORKED, thanks to these guys for making a affordable servo for any build. This isn't bad if you're upgrading a toy. But I wouldn't recommend this for like any high end drift RC or anything like that. I don't know about any of the higher KG ones but the 20kg seems a little jittery. Otherwise performed okay enough for the build it went in.
Ernest G.
August 18, 2025
Great little servo ... but it is "almost" too big for the Traxxas TRX4M crawlers. I say this because I had to file the case down ever so slightly to get it to fit. But now that it is installed my grandson is delighted that his favorite RC car is back in service. The question now: Will it last longer than the original Traxxas servo ... which only lasted 30 days or so of more or less continuous duty at the hands of a 7- year old boy.
John Hawk
August 5, 2025
Easy install. Works perfect.
BuyerOfThings
July 27, 2025
This servo, based on my limited experience so far, is not great.The included clamp-on horn does not center when installed so I need to do a lot of pre-trim and EPA adjustments for it to work on my install. This is likely because it's 25 teeth and I need to poke out with the horn facing away from the body, not inline with the body.The servo struggles to reach its endpoints, creeps very slowly for the last few degreesThe servo does not re-center reliably.For the money, it'll do, and it seems to have decent torque at 7.4 volts. It's also not the slowest servo I've ever used!But, it's blue aluminum and matches some of the other bling on my build so it's OK :) Plus it's better than spending $100 on a real servo.
Heather A
July 25, 2025
Great and powerful!
jon gerhards
July 18, 2025
Had this on for awhile after I cooked my stock Traxxas steering servo (shocking ik) I was a bit hesitant but after abusing this thing as much as I could it's still kicking strong! If your running a trx4 I highly recommend upgrading your axle mounts to brass at the same time I thought I killed this servo but turns out I snapped a mount!
Jaime E.
July 8, 2025
Buen servo.
Issam Hamad
June 22, 2025
The product is perfect without any scratches or manufacturing deffects. The product reached to me as per the descriptions and the quality is really high. I recommend everyone placing the order from this seller.
Mohammed dawood
June 16, 2025
Ùنان
Devon
June 11, 2025
Super slow. No good for bashing or racing. Might be ok for crawling.
FasEddie
May 30, 2025
With these budget servos, no need to spend this much, sb around $30 usd….don't buy.
ViDiViCi
May 24, 2025
The media could not be loaded.
Dan Homeyer
April 30, 2025
35g-20g THE BEST for your budget builds, The only difference between the higher dollar comparable ones is a little gear noise but these are plenty strong and long lasting. I have six 3- 35s and 3 -20s for over 2years, Zero problems never even get warm even when 95 outside......ALWAYS make sure of your end point adjustments and your servos will last. The 20s are perfect for Digs+Overdrives. OH, And do not put any servo to the WDW torture test. Nothing can handle that punishment for long....
Orion W.
April 6, 2025
It seems a bit weak for what task I put it up to. Which was replacing the old non hobby grade servo in my RadioShack Tremor, with a hobby grade one. Which worked. Sadly I had to trim the tabs off :'( BUT IT WORKED, thanks to these guys for making a affordable servo for any build. This isn't bad if you're upgrading a toy. But I wouldn't recommend this for like any high end drift RC or anything like that. I don't know about any of the higher KG ones but the 20kg seems a little jittery. Otherwise performed okay enough for the build it went in.
Ernest G.
March 17, 2025
Great little servo ... but it is "almost" too big for the Traxxas TRX4M crawlers. I say this because I had to file the case down ever so slightly to get it to fit. But now that it is installed my grandson is delighted that his favorite RC car is back in service. The question now: Will it last longer than the original Traxxas servo ... which only lasted 30 days or so of more or less continuous duty at the hands of a 7- year old boy.
John Hawk
March 13, 2025
Easy install. Works perfect.
BuyerOfThings
March 10, 2025
This servo, based on my limited experience so far, is not great.The included clamp-on horn does not center when installed so I need to do a lot of pre-trim and EPA adjustments for it to work on my install. This is likely because it's 25 teeth and I need to poke out with the horn facing away from the body, not inline with the body.The servo struggles to reach its endpoints, creeps very slowly for the last few degreesThe servo does not re-center reliably.For the money, it'll do, and it seems to have decent torque at 7.4 volts. It's also not the slowest servo I've ever used!But, it's blue aluminum and matches some of the other bling on my build so it's OK :) Plus it's better than spending $100 on a real servo.
Heather A
March 3, 2025
Great and powerful!
jon gerhards
February 20, 2025
Had this on for awhile after I cooked my stock Traxxas steering servo (shocking ik) I was a bit hesitant but after abusing this thing as much as I could it's still kicking strong! If your running a trx4 I highly recommend upgrading your axle mounts to brass at the same time I thought I killed this servo but turns out I snapped a mount!
Jaime E.
January 31, 2025
Buen servo.
Issam Hamad
January 25, 2025
The product is perfect without any scratches or manufacturing deffects. The product reached to me as per the descriptions and the quality is really high. I recommend everyone placing the order from this seller.
Mohammed dawood
January 9, 2025
Ùنان
Devon
November 30, 2024
Super slow. No good for bashing or racing. Might be ok for crawling.
FasEddie
November 22, 2024
With these budget servos, no need to spend this much, sb around $30 usd….don't buy.
Recommended Products