Your cart is empty.
Your cart is empty.Dobicassie
2025-08-06 11:01:30
Our toilet leaked at the foot pedal. After installing the replacement part it leaked a little until the line cleared, then nothing. It's been great ever since
Customer
2025-07-22 10:01:51
I installed these in my toilet. They are junk. Leaked from the time it was turned on and flooded my floor. Both valves did the same thing in the same spot. Defective valves.I went and purchased two from the camper supply store, installed it and it worked perfectly. No leaks and a happy camper.There is a reason they are $17 and the camper store charges $85. Do not waste your money on these - gonged the good valve and spend a little money, but not waste your time.These are cheaply built. Look at the two side my side and it is obvious. Cheap for a reason - trash!!!!
MysticLizard
2025-05-23 17:00:33
This is used as a replacement pump for a RO system the internal pump failed in. Flow is slightly less than original but this little pump has enough pressure to filter water with no problems. I picked up a barrel connector to hook directly to battery pack in filter but pump comes with a 110v wall wart to power it. It has a switch inline so you don't have to plug and unplug for off and on.Would work great for irrigation system or transferring water from rain barrels.Much quieter than original pump and considerably smaller. Comes with everything needed to use out of box including a length of tube.Great value and easy to use. Like that it is 12v dc for safety around liquids.Keeper!
Garrett Larkin
2025-04-20 15:37:11
Always good to have a spare and these work just fine.
Skibum
2025-03-20 20:15:11
I had water leaking from the bowl AND from the valve onto the floor. So this was a great bundle for me. And it came with two bowl seals. Both the bowl seal and the valve were EASY to replace WITHOUT having to remove the toilet. You don't need to be a toilet tech.But, in order for the bowl seal to work properly, you must clean the rim where the seal seats and the "ball". I used white vinegar and a kitchen sponge with scotchbrite on one side. I would not use a chisel and hammer. Throw the sponge away when done. And do I really need to say it... wear rubber gloves and eye protection... and WASH YOUR HANDS afterwards.PS: I used plenty of cheap petroleum jelly on the bowl seal and the "ball" when installing.
David Brown
2025-01-24 15:13:19
I ordered 2 to have a spare one on hand. Installed the first one and it began leaking as soon as I turned on the water from the actuator pin. Installed the second one and now it is leaking from the the same location 2 weeks later. I have a pressure regulator on the water line so that’s not the issue. Beware of china produced products.
denise
2024-12-19 17:32:51
It was exactly what I needed and worked as described, and was extremely easy to install probably saved my RV.
Recommended Products