Your cart is empty.
Your cart is empty.This "Made in the USA" socket was specifically designed by a Master Technician to make the difficult task of replacing the ICP sensor on the early (up to 9/22/03) 6.0L a little easier. It also fits 7.3L ICP's and 6.0L engine oil pressure sensors perfectly. On early build 6.0L diesels, the ICP sensor is located in an extremely confined area under the turbocharger. Attempting to change the sensor using a standard socket will prove to be either a very difficult or impossible task because of the tight clearances involved. Our 3/8th in drive socket is designed to be as small as possible, both in length and diameter so that it will fit between the high pressure oil pump cover and the sensor and also allow as much clearance as possible at the end of the socket. Depending on user preference, the ICP sensor can be accessed either from above or below the truck.
Pauly
2025-08-07 11:36:26
Worked great on my early build 2004 6.0 powerstroke.
TheLua's
2025-08-04 13:42:17
Used this for my 6.0 ICP sensor. This fit so perfectly and easily, I wish I had purchased it FIRST instead of being cheap and trying to use a deep socket, as some forums recommended. The socket I tried using was just a basic Dewalt impact rated deep socket.
jordan s. colby
2025-07-20 11:14:43
The media could not be loaded.
Nicole
2025-06-03 10:36:54
Works great
Mariah N. Bargman
2025-05-28 13:23:20
Fits perfectly to remove the ICP!
Andrew B
2025-04-27 15:35:21
Very pleased to have this in my toolbox! I've replaced my icp sensor without any special tools and I regret not just buying this to begin with. Took about 4 hours my first time and only an hour the second time using this.
Customer
2025-04-24 14:05:07
Right part 1st time.
Amazing
2024-12-16 10:44:54
Works properly
Recommended Products
