Shopping Cart

Your cart is empty.

Your cart is empty.

Alla Lighting 7440 T20 50W 6Ohm Error Free LED Lights Load Resistor Adapter Fix Flashing Fast Blinking Canbus Bypass Wiring Harness for Upgrading LED Turn Signal Blinker Light Lamps

Free shipping on orders over $29.99

$19.99

$ 9 .99 $9.99

In Stock
  • ATTENTION: This load resistors may not be able to plug into the stock harness, Please check the stock housing to confirm the load resistor can fit itno the housing before purchasing (Amazon fitment is only for reference, not 100% accurate)..2pcs 7440 50W 6Ohm LED Load Resistors for LED Error code Fix or Anti-Flicker (Solving signal hyper flash); Easy Installation: All-in-One Design. Plug and Play Setup for LED turn signal light,back-up reverse light. Average Installation time: 15-20 minutes
  • Aluminium Shell; Excellent heat dissipation. One LED resistor is required for each bulb
  • Solves the problem of LED bulbs flashing/flickering when installed. please make sure metal resistance not contact with plastic wire to prevent the plastic from melting.
  • Clears OBC and CAN-BUS warning errors on the dashboard when LED bulbs are installed.
  • Cross reference number: 7440, 7441, T20, W21W, etc. Used for: halogen/ incandescent front rear turn signal blinker light, back-up reverse light lamps upgrading led bulbs.


This listing features one pair ( 2 pieces) 7440 50W 6ohm load resistor to avoid the error code on the dash board or flicking on-off due to led bulbs draw much less current than stock lamp, directly plug and play, easy installation.

Features:

--- Directly plug and play, easy installation,

--- Cancel Error Message cause by OBC (On-Board Computer) Check. Cancel Hyper Blink on LED Headlight

--- Permanently resolve the annoying LED turn signal light flickering problem

--- Includes 2 pieces 7440 50W 6ohm load resistors per order.


Gary
2025-08-21 15:50:38
Installed alla brand LED reverse bulbs in my 2021 Camaro while they were very bright they did not work properly. I phoned the company in CA. and they were very helpful. Recommended this product. Although there are 2 bulbs I only had to install 1 resistor. It cured the problem and work great. Company rep was very nice and helpful will shop there again.
Alfonso Piña
2025-08-18 16:11:51
After a few hours of running them in my 2020 Colorado they did not work correctly and they were hyper flashing on their own without any turn signals or stoplights Save yourself the headache and don’t buy this product
Cameron Harrison
2025-07-02 09:46:17
You attatch them to your bulb sockets except when you use the brakes it does the same flash as the blinker and then turns off, they make the blinkers work but the brake lights wont when you use the pedal.
Richard G.
2024-12-20 10:50:48
After several emails I couldn't get them to fix the problem. I ordered some resistors, installed then properly and made sure the bulbs and vehicle where compatible. And they still went around it and blamed my installation.
Recommended Products