Your cart is empty.
Your cart is empty.Product Description
What You Get:
Momentary Polarity Reverse Switch+4pcs connect wires
Application:
This is a common jack on factory installed on most Travel Trailers.
This polarity reversing switch easy replacement for most RV / trailer power tongue stabilizer Jacks, Fits many fifth wheel jacks, and replaces some power awning switches.
Momentary Polarity Reverse Switch (ON)- OFF-(ON) 125V AC 10A 250V AC 16A
Install Size: 20 mm (0.787 inch)
- Switch Rating: 250V AC, 16A
- 125V AC, 10A
- Pre-wired length: 200mm (7.87 inch)
- Contact Type: DPdT, 4Pin
- Operation: (ON)- OFF-(ON)
- Color: Red
- Electrical Life : ≥15000 Cycles
Pre-wired Design
The rocker switch is pre-wired with 200 mm cable. The connector is covered by rubber and not easy to fall off.
Long Work Life
More than 1,5000 times electrical work life.
Snap-In Design
Snap in Design make the switch easy to install. Extruding the plastic part, then Push in to the Panel.
Inflaming Shell
High temperature resistance and anti-flaming Shell. More safe for using.
About APIELE
APIELE is a professional Switch supplier. We try to satisfy all Switch demand of our customer with advanced products, competitive prices, fast delivery and one-stop service.
Professional Technical Support
APIELE provides you with professional technical support services. If you encounter any problems during use, please contact APIELE, and you will get a perfect solution.
Quick After Sales Service
Staffs in our service team have rich experience in after-sales service. Email will be respond within 18 hours. We provide 1-2 years after sales service for different products.
Upsi
2025-08-28 17:03:57
Old switch failed due to corrosion this one was half the price of the one the dealer had to offer and I didn’t have to drive 60 miles round trip to pick it up
tom nolan
2025-08-12 11:44:49
Small, easy to recess, works as designed. Reasonably priced.
Ralph L.
2025-07-31 18:30:09
Liked the switch as it was prewired
aaron
2025-07-19 13:47:05
GREAT PRICE
Newkid67
2025-07-18 18:13:51
It worked for my Flagstaff MicroLite 2019 model. It feels lighter probably more plastic than the OEM part but it was a snap fit. (The original only lasted three years soo) Wiring was simple swap over, just take a photo of original wire color placement and attach to new switch in same order. Done ðŸ‘
Bob
2025-07-16 12:55:14
Switch worked fine but clips to hold switch broke. It was cold in the garage when I put it in so I will warm up switch prior to installation. The plastic is very very brittle. I had to order another and hopefully it won't break. Update, second one I put in the tabs also broke and had to hot glue in.
Wade Branham
2025-06-08 16:52:21
It did what it was supposed to do....
GAVIN E.
2025-05-21 19:15:08
Â
Al
2025-02-19 14:22:55
Used it for my rv jack
Recommended Products