Your cart is empty.
Your cart is empty.Product Description
B. Peterson
2025-09-03 11:34:31
Only printed on it a few times, no failed prints, but one print may have shifted a very slight amount due to not using a brim, and the section with the print flaw was quite thin, so it could have warped.
JK
2025-08-31 10:41:25
They aren't as grippy as a normal textured build plate, but the finish they leave on prints is stunning! They feel nice and sturdy, and are definitely worth the money.
Sara R
2025-08-14 15:00:58
I’ve done a few prints using my A1 with these plates. Pattern transfers well and the adhesion has been great. I have found the pattern sort of “wears off†the print if you handle it a lot (fidgets and such) but the pattern comes right back if you wipe the print with isopropyl alcohol
Oh hey...
2025-08-01 14:15:23
This isn't my first holographic pattern plate (I have lots of other patterns), but it has been one of the easiest to print with. After peeling off the protective coating and cleaning with hot water and dish soap, I pulled out some old PLA (without even drying it), tossed the plate in (using the textured plate settings), and away I went. Everything stuck well and after cooling, slid right off with just the slightest of touches. My print turned out perfect and the holographic pattern looks great. I would definitely get this again if my plate ends up getting damaged or worn out over time.
Rodney
2025-07-27 13:55:50
Serious adhesion issues. Pattern rubs off finished prints
Bob
2025-06-20 16:32:45
I have had a bit of a sticking problem with these but the effect is pretty cool so I will keep trying to make them work. I don't want to use glue as it removed the effect from the print and leave the glue mess. I tried hairspray and it had a similar issue. I have cleaned with soap and water and had limited success. I will keep trying different filaments to see which works the best.
AiRoKa
2025-02-07 12:34:48
This effect plate does work, which still blows my mind, but it's definitely a little finicky for me. Definitely will need big surface items for this otherwise you have to worry about adhesion issues. Naturally can't use any gluestick on this since it'd ruin the effect.But in either case it's been a great little addition to my Bambu X1C. I don't use it often but when I do it always impresses me what it does.
Jeremy
2024-12-19 12:52:47
The textures of this plate are a novelty, but I find them to be pretty entertaining. The plate is sturdy and fit my P1S perfectly, as expected. The adhesion has been great, so even if you don’t care about the texture, it’ll print nicely out of the box. If you want a neat look on your flat surfaces, check this out.
Recommended Products