Your cart is empty.
Your cart is empty.IdeaFormer-3D Smooth H1H Build Plate for Creality K1 Max, Ender 3 V3 Plus Double Sided Rainbow Streak+Phantom H1H Spring Steel Bed Plate Flexible K1 Max Sheet 315x310 mm No Magnetic Plate
mnq
2025-08-24 14:53:34
I print a lot of large pieces and these plates are fantastic. ABS sticks like glue (minus glue) and every type of PLA sticks to the smooth side with just a light rubdown of glue (3D printer specific). The smooth side leaves a pattern on the prints that just looks cool so you have functional, and fun 🤩.I bought two because as soon as one job ends I just swap the plates and run the next batch. Never had any issue with release either if you take the time to let the plates cool (which is the reason I bought two).Will 100% buy these again but after almost 100 prints they show zero wear so I don’t see needing to replace these anytime soon.For specifics I use these on an Ender 3 v3 Plus running anywhere between 65 and 100 degrees for the bed temp and 275mm/s to 600mm/s speeds.
Drey Digital
2025-08-20 15:18:55
Adhesion is amazing and love the effect that it gives!
Blair Diaz
2025-07-31 10:46:58
I got this because my OEM build plate was getting worn out. I use Elegoos rapid pla + and it sticks just fine I'm very happy.
agustin
2025-07-24 21:47:03
love the design of the pattern
David McFarland
2025-07-10 15:06:40
The media could not be loaded.
Kody
2025-06-15 17:40:13
Works as advertised and is the same or better quality as the stock plate super easy to remove stuff and have had no adhesive issues whatsoever with a little bed adhesive . Leaves the texture on the prints looks so cool great product
robin rozzelle
2025-05-13 21:59:58
I ordered this for a specific printer and the slots in the back arent even close. Other than that works Ok so far.Contacted them about the problem and promtly made it right . THANKS
Joe D.
2025-03-30 16:30:31
With these build plates you do need good adhesion. If you need any glue stick or anything like that, it’ll ruin the holographic results.For me, pla adhered well and the k1 did everything automatically.Cool effect, not sure how long it’ll last, but it has worked after about 6 prints.
Geobig
2025-02-22 11:58:32
Good quality product. Works better then the original Creality build plate nice to have the PEO side for PLA prints that need a smoother bottom layer.
Oliver
2025-02-06 11:57:48
The pattern transfers on to the print fine, and it fits my K1 MAX perfectly. However, it is difficult to get the prints to adhere to the plate. Lots of failed prints and wasted filament.
F.
2025-02-01 10:40:04
Works great, durability im not sure as its not my main plate.Adhesion is good.
Melissa
2024-12-20 13:06:42
Requires glue won't stick to bed completely but does print out nicely 👌
Recommended Products
