Your cart is empty.
Your cart is empty.Buyers Products Large Folding Step is designed for use on trucks and emergency vehicles and conforms to NFPA specifications. The large 7-1/4 in. by 6-3/4 in. step features chrome-plated, die cast construction and stainless steel springs to keep the step firmly open or closed as needed. The chrome-plated finish adds corrosion protection and a custom look. The step conforms to the National Fire Protection Association (NFPA) specifications for use on emergency vehicles and has a larger footprint to accommodate heavy boots and equipment. Product Common Use: Emergency Vehicles, Utility Trucks, Work Trucks, Semi Trucks
Preceng
2025-08-25 14:13:17
Makes getting in/out of the skid loader much easier! Very heavy duty step. Bought one for each of my loader buckets.
Michael G.
2025-08-14 15:30:06
Good product and fast shipping
Dog lover
2025-08-01 17:01:47
I used this to provide a second high step into the 8 ft bed of my F350. I installed it 5 inches behind my fuel refill door. I cut grey trex decking material available at Lowes to reinforce the panel. I made a U shaped bracket with the trex and screws that was 4 7/16 wide so that it would fit very snugly between the truck bedliner steel and the door panel then placed stainless steel screws to hold in place from the bedside. Then I made a trimmed edge paper template for the screw holes for the folding step and drilled a very small pilot hole to make sure it was at the right edge location. Then using gradually increasing size of the drill bits I enlarged the door panel holes up to 5/16 size. This step was important because if the holes are not very exact you will have problems threading the bolt. I then placed four 8 inch long 5/16 inch galvanized carriage bolts thru the folding step after I glued the soft washer plate in place. As the bolt travelled thru the trex U bracket I added galvanized washers and bolts and two flat steel reinforcement plates I had drilled out with 3/8 holes to further stiffen the support. I cut off about 1 1/2 inch of the bolts before adding a cap nut to each at the inside of the truck bed. I also had to purchase an extra long 5/16 inch metal drill bit. After tightening down all the bolts, the step can take my 180 pound weight without causing any flexion of the exterior wall panel of the truck. I have attached install photos.
Holly
2025-06-17 17:01:52
This step is heavy duty,im using it in my boat to help handicap person getting in and out of the boat.
Customer
2025-06-04 16:44:34
Bought this to install on my bowfishing boat to split the distance between my deck and boat. Very solid and well built. Went out this weekend and it worked great. Easy install. Does not come with bolts or nuts.
Byron Sheardown
2025-05-03 15:30:21
Difficult to open. The spring is very tight.
class2canoe
2025-04-12 12:42:22
This is a great step up. It is heavy and seems heavy duty. It is a little hard to open and close. We put a good dose of grease in it and I can raise and lower it with my hands. The "diamond teeth" on top of it are sharp and will cut you. I will put a thin rubber layer on mine to keep it from hurting my feet when I get up and down from the bed in my gooseneck horse trailer. I would have given 5 stars if the "teeth" weren't so sharp.
Chopperdawg Motorcycles
2025-04-11 10:19:10
I have a custom made utility body truck for work,I put these on the back and boy do they make life easier.Price was good too. I got my second set today.I got the first set last week for my truck and I love them! Nice wide,deep step.Makes climbing up onto the bed of my truck so much easier.I got the second set for the front of the body so I can reach the front of the ladder racks.
Andrew Lawson
2025-03-18 12:32:34
Probably made to well & weighs a heap.The spring is that tight that its impossible to pull down & be used as a foldable step, therefor not fit for purpose & the weight is an issue at around 4klgs.Wouldnt reccomend
Réal Bouillon
2025-02-12 16:34:15
Fixé à mon camion
Keith Price
2025-02-06 17:03:54
Great product, great quality. Exactly what I wanted.
Chris R.
2025-01-18 13:50:41
The item is so tight I could not open it without using tools!
Recommended Products
