Your cart is empty.
Your cart is empty.Product Description
10 Gigabit Performance for Critical Connections
Connect your high-bandwidth network with confidence. These fiber optic patch cables are OS2 rated for the extreme demands of SAN networks. They are precision factory tested for insertion and return loss to ensure transmission performance per TIA-568-C.3 specifications. The combination of LC to LC connectors in a protective yoke, strain relief boots and zirconia ceramic ferrules provides dependable, low-loss performance.
Full-Featured LC to LC OS2 Fiber Cable
1. Easy to identify yellow and white boots with 1 & 2 ring makers
2. Slim-profile strain relief boots provide durability and flexibility
3. Adjustable yoke un-snaps to reverse polarity
4. Removable dust caps prevent dirt from reaching the fiber
Adjustable Yoke with A & B Labels
- Classification: OS2
- Wavelength Support: 1310nm / 1550 nm
Superior Materials
- Duplex zipcord with 2.0mm legs (2.0 x 4.0mm)
- Aramid yarn strength member
- Ceramic ferrule for precise alignment
Plenum Jacket Fire Safety-Rated
- Safe in plenum air spaces
- Meets UL 910 requirements
- Substitutes for OFNR riser
Kyle
2025-07-28 13:00:03
Great quality cable
alh
2025-07-09 14:47:01
straightforward, good quality, no problems
Garrett
2025-04-04 11:07:43
This fiber cable worked.
Arthurs E.
2025-03-21 15:57:42
Satisfied
Kevin
2025-02-26 17:35:06
I have a lot of fiber converters to get back into copper and these patch cables do the job.I am not an expert. They work. No idea how to compare one cable to another. They work, period.
Mark D
2025-01-04 12:23:04
I'm using this to connect two single mode transceivers and this cable links up at 10G immediately. No problems at all.Things to note:This is a thinner OS2 cable, so it is likely fragile and care should be taken when installing or using. That being said, I use this in a patch scenario and it is moved around quite a bit without issue.The lc ends fit splayed little too wide in the clips, so you may have to lightly squeeze the cables together on insertion.Also note if your transceivers are single mode or multimode. Generally this single mode cable won't reliably connect multi-mode fiber hosts. Most cheaper transceivers are multi-mode, which uses less focused lower output lighting diodes. If you're having connection problems, make sure you bought the right cabling! If you can't easily see light output from the TX end of your host, a mismatch of cabling and transceivers is likely the problem.
RunRaptorRun
2024-12-21 13:39:54
This cable is well made and performed as expected though I only tested with 1GbE. No errors or dropped packets during a network link stress test.The connectors hold on to the transceivers snuggly.Not much more to say than that... very pleased. I've never had a problem with this cable brand.
JARELLANO
2024-12-12 10:48:00
The media could not be loaded.
Recommended Products